There are many advantages of floating wind turbines in deep waters, however, there are also significant technological challenges associated with it too. The dynamic excitation of wind and waves will induce excessive motions along each of the 6 degrees of freedom (6-DOF) of the floating platforms. These motions will then be transferred to the turbine, and directly impact the turbines’ performanc...

The sea-surface microlayer (SML) at the boundary between atmosphere and hydrosphere represents a demanding habitat for bacteria. Wind speed is a crucial but poorly studied factor for its physical integrity. Increasing atmospheric burden of CO2, as suggested for future climate scenarios, may particularly act on this habitat at the air-sea interface. We investigated the effect of increasing wind ...

In recent years, train speeds have been increased for earlier arrival times as part of efforts to improve service to travelers. Meanwhile, the speed of train drafts (the winds generated when trains pass by station platforms) increases in proportion to the train speed. JR companies have therefore deployed adequate safety measures such as the installation of platform doors and aerodynamic optimiz...

the study of interactions of jet into cross flow at different longitudinal and transverse angles ofjet was studied. the following components were designed and constructed: a low velocity windtunnel to produce the uniform flow, a flat plate with a traverse injection system to simulate the jetinjection, and a spatial rake to measure the total pressure. the tests were carried out atlongitudinal (α...

designing and manufacturing the multiple jets simulator and experimental investigation of the multiple jets in crossflow at low velocity ratios have been studied together with design and build a low-speed wind tunnel. a specific rake is used to determine the flow field pressure and changes in static pressure measured by pressure taps in the near field of the jets. there are generally three regi...

The roll dynamics of a 5kg, 1.3 m high sounding rocket are analyzed in a vertical wind tunnel. Significant turbulence in the tunnel makes the system identification of the effective inertia, damping and asymmetry with respect to roll challenging. A novel method is developed which decouples the disturbance from the rocket frame’s intrinsic roll dynamics and allows accurate prediction of roll rate...

Article history: Received: 19.06.2014. Received in revised form: 06.11.2014. Accepted: 11.11.2014. According to the galloping mechanism of iced conductors, the aerodynamic simulations were performed based on actual wind tunnel tests. Aeroelastic models of single and bundled conductors with a typical ice-coating section forms (crescent section) were set up. The simulation results were in good ag...

Feeder is one of the airships of the Multibody Advanced Airship for Transport (MAAT) system, under development within the EU FP7 project. MAAT is based on a modular concept composed of two different parts that have the possibility to join; respectively they are the so-called Cruiser and Feeder, designed on the lighter than air principle. Feeder, also named ATEN (Airship Transport Elevator Netwo...

The effect of skis on the force-time characteristics of the simulated ski jumping takeoff was examined in a wind tunnel. Takeoff forces were recorded with a force plate installed under the tunnel floor. Signals from the front and rear parts of the force plate were collected separately to examine the anteroposterior balance of the jumpers during the takeoff. Two ski jumpers performed simulated t...

Synchronous wind-induced pressures, measured in wind-tunnel tests on model buildings instrumented with hundreds of pressure taps, are an invaluable resource for designing safe buildings efficiently. They enable a much more detailed, accurate representation of the forces and moments that drive engineering design than conventional tables and graphs do. However, the very large volumes of data that...