Hertz contact theory has been widely used for the determination of cell elasticity based on AFM indentation experiments. In light of the adhesive contact between AFM tip and cell, this study applied Johnson-Kendall-Roberts (JKR) model to fit the indentation force-displacement (F-D) curves reported previously. A MIN6 cell has been modeled as first a sphere and then a flattened cell with differen...

Examination of deformation microstructures induced by micro-indentation technique by means of transmission electron microscopy following an MV range metallic ion irradiation was performed in order to study the influence of irradiation-produced microstructural defects on plastic deformation behavior of materials. In this work, specimens of an Fe-Cr-Ni austenitic model ternary alloy before and af...

In order to better exploit the natural cork available in Algeria, an experimental characterisation of a jute/ epoxy–cork sandwich material to impact and indentation was undertaken. The aim of this work is to evaluate the impact energy and cork density influence over the sandwich plate damage behaviours by instrumented static and dynamic tests. The results show that the onset damage force, the m...

This study compared the fracture toughness values (KIC), which were derived from simplified techniques: the indentation fracture (IF), the indentation strength (IS), and fractographic approach to that from a standard testing using surface cracks in flexure (SCF). Forty bar specimens, twenty IPS Empress(®) Esthetic and twenty IPS e.max(®)Ceram were prepared. Ten specimens in each material were t...

This paper clarifies a common misunderstanding of the phase transformation in monocrystalline silicon under nanoindentation, namely that a pop-out represents the onset of a phase transition. Through a detailed investigation into the indentation-induced deformation of monocrystalline silicon using a Berkovich indenter, it was found that a pop-out does not correspond to the onset of the transform...

Average stress during shear bond testing, and deformation behaviour during nano-indentation testing were calculated for the bonding area as a bonding site for copolymerization with resin composite in dentine bonding systems. First average stress was calculated in the bonding area between bovine dentine and composite resin. Secondly, the plastic deformation zone size was calculated using an elas...

Atomic force microscopy is an established technique for probing the local elastic properties of materials at submicron scales. In some cases, linear elastic contact theories based on Hertzian and adhesive contact mechanics suffice to model the indentation process. However, at the large strains that are common in many nanoindentation experiments, the linear models become invalid. A force-indenta...

Scanning- and colloidal-probe atomic force microscopy were used to study the mechanical properties of poly(L-lysine)/hyaluronan (PLL/HA)(n) films as a function of indentation velocity and the number of polymer deposition steps n. The film thickness was determined by two independent AFM-based methods: scratch-and-scan and newly developed full-indentation. The advantages and disadvantages of both...

Viscoelastic mechanical properties of biological cells are commonly measured using atomic force microscope (AFM) dynamic indentation with spherical tips. A semiempirical analysis based on numerical simulation is built to determine the cell mechanical properties. It is shown that the existing analysis cannot reflect the accurate values of cell elastic/dynamic modulus due to the effects of substr...

Measurement of the strength of brittle materials, such as resin composites, is extremely difficult. Micro-indentation hardness testing is a convenient way of investigating the mechanical properties of a small volume of material. In this study, the mechanical properties of five commercially available flowable resin composites were investigated by the dynamic micro-indentation method. Additionall...