Copper indium gallium selenide (CIGS)-based solar cells have exhibited greater performance than the ones utilizing cadmium telluride (CdTe) or hydrogenated amorphous silicon (a-Si: H) as absorber. CIGS-based devices are more efficient, considering their device performance, environmentally benign nature, and reduced cost. In this article, we proposed a potential CIGS-absorber-based cell with an ...

Reducing absorber layer thickness below 500 nm in regular Cu(In,Ga)Se2 (CIGS) solar cells decreases cell efficiency considerably, as both short-circuit current and open-circuit voltage are reduced because of incomplete absorption and high Mo/CIGS rear interface recombination. In this work, an innovative rear cell design is developed to avoid both effects: a highly reflective rear surface passiv...

cylindrical thin-walled tubes due to construction and easy installation, high energy absorption capacity are used in the automotive industry as an impact energy absorber. however, the main weakness of cylindrical tubes is in the high initial peak load. therefore, in this paper, to overcome this weakness, a buckling initiator is used at the top of the tube. this buckling initiator is a steel rod...

The red quasar 3C212 (z = 1.049) is one of the most distant and most luminous AGN which has shown evidence of an X-ray warm absorber. In order to further investigate this unusual quasar, we used Chandra/ACIS-S to observe 3C212 for 19.5 ksec, resulting in a net detection of ∼ 4000 counts. The Chandra data confirm the presence of an excess absorbing column NH ≈ 4 × 10 21 cm at the quasar redshift...

The interaction between trace shortwave radiative absorbers and the dynamical circulation is shown to be linearly unstable for horizontally uniform basic states with a vertical gradient in the basic state absorber mixing ratio. Two types of instability are identified, described as the advective mode and the propagating mode. The advective mode is usually unstable when the basic state absorber m...

Efficient photocatalytic water splitting requires effective generation, separation and transfer of photo-induced charge carriers that can hardly be achieved simultaneously in a single material. Here we show that the effectiveness of each process can be separately maximized in a nanostructured heterojunction with extremely thin absorber layer. We demonstrate this concept on WO3/BiVO4+CoPi core-s...

Nowadays, polymer nanofibers have gained attention due to remarkable characteristics such as high porosity and large surface area to volume ratio. Among their fabrication methods, electrospinning technique has been attracted as a simple and reproducible approach. It is a versatile, simple and cost-effective technique for the production of continuous nanofibers with acceptable characteristics su...

This paper presents a wide-angle polarization independent triple-band absorber based on a metamaterial structure for microwave frequency applications. The designed absorber structure is the combination of two resonators (resonator-I and resonator-II). The proposed absorber is ultrathin in thickness (0.012λo at lowest resonance frequency and 0.027λo at highest resonance frequency). The proposed ...

We present a detailed theoretical description of a broadband omnidirectional light concentrator and absorber with cylinder geometry. The proposed optical "trap" captures nearly all the incident light within its geometric cross-section, leading to a broad range of possible applications--from solar energy harvesting to thermal light emitters and optoelectronic components. We have demonstrated tha...

The optical absorption efficiencies of vertically aligned multi-walled (MW)-carbon nanotube (CNT) ensembles are characterized in the 350-7000 nm wavelength range where CNT site densities > 1 × 10(11) /cm(2) are achieved directly on metallic substrates. The site density directly impacts the optical absorption characteristics, and while high-density arrays of CNTs on electrically insulating and n...