A three-dimensional large-sliding contact model coupled with strain-induced phase transformations (PTs) and plastic flow in a disk-like sample under torsion at high pressure in rotational diamond anvil cell (RDAC) is formulated and studied. Coulomb and plastic friction are combined and take into account variable parameters due to PT. Results are obtained for weaker, equal-strength, and stronger...

We study quasistatic evolution problems for pressure-sensitive plastic materials in the context of small strain associative perfect plasticity.

The plastic deformation of Ti45Zr16Be20Cu10Ni9 bulk metallic glass has been investigated by nanoindentation performed with loads ranging from 10 to 200 mN in a wide range of loading rates. The plastic flow in the alloy exhibited conspicuous serrations at low loading rates. The serrations, however, became less prominent as the rate of indentation increased. Atomic force microscopy showed a signi...

Existence of plastic equation of state has been investigated by performing a series of load relaxation tests at various temperatures using an Al-Li alloy. A plastic equation of state is first developed from a simple kinetics consideration for a mechanical activation process of a leading dislocation piled up against grain boundaries. A series of load relaxation test has been conducted at tempera...

The algorithmic consistency conditions are derived which yield the plastic loading index for the combined isotropic– kinematic hardening plasticity with the Armstrong–Frederick evolution equation for the back stress. Rate-independent elastic–plastic, and rate-dependent viscoelastic–plastic and elastic–viscoplastic material models are all encompassed by the analysis. The directions of the plasti...

The plastic blunting process during stage II fatigue crack growth was studied in pure polycrystalline Ni to investigate effects of strain localization and inelastic behavior on the kinematics of crack advance. Correlations were obtained between strain fields ahead of a fatigue crack, crack advance per cycle and crack growth kinetics. Strain fields were quantified using a combination of in situ ...

We analyze in detail the atomistic response of a model amorphous material submitted to plastic shear in the athermal, quasi-static limit. After a linear stress-strain behavior, the system undergoes a noisy plastic flow. We show that the plastic flow is spatially heterogeneous. Two kinds of plastic events occur in the system: quadrupolar localized rearrangements, and shear bands. The analysis of...

fabrication of ultrafine grained materials by imposing severe plastic deformation for improvement of mechanical and physical properties of metals has been the focus of many researches over the past few years. in this process, a sheet is subjected to repetitive shear deformation conditions by utilizing asymmetrically grooved and flat dies through alternate pressing. in this study, a 2mm thick co...

This paper briefly reviews progres~ in the elastic plastic analysis of crack extension. Analytical results for plane strain and plane stress deformation fields are noted, and elastic-plastic fracture instability as well as transitional behavior and combined rate and thermal effects are discussed.

A framework for development of constitutive models based on semi-micromechanical aspects of plasticity is proposed. The resulting of this model for material employed friction type failure criterion, sub-loading surface, and associated flow rule. This model is capable of predicting effects of the rotation of principal stress/strain axes and consequent plastic flow, induced anisotropy of strength...