3 Ordered Cu-(35–50) at.% Pd alloys (B2-type superstructure) have a high corrosion resistance and are distinguished by possessing very low electrical resistivity r » (4–8) × 10 ohm m (1), two properties which make them of interest to researchers developing functional materials. However, wide-scale use of these alloys is hindered by their relatively poor strength properties: the yield stress of ...

Sinkholes in dolomitic areas are notoriously difficult geophysical targets, and selecting an appropriate geophysical solution is not straightforward. Electrical resistivity imaging, or tomography (RESTOM) is well suited to mapping sinkholes because of the ability of the technique for detecting resistive features and discriminating subtle resistivity variations. RESTOM surveys were conducted at ...

Raman spectroscopy, synchrotron angle-dispersive X-ray diffraction (ADXRD), first-principles calculations, and electrical resistivity measurements were carried out under high pressure to investigate the structural stability and electrical transport properties of metavanadate MgV2O6. The results have revealed the coordination change of vanadium ions (from 5+1 to 6) at around 4 GPa. In addition, ...

Ultra-low-energy secondary ion mass spectrometry has been used to undertake a structural analysis of GaN-In(x)Ga(1-x)N (x approximately 0.25) quantum wells used in optoelectronic devices. The high resistivity of intrinsic GaN-In(x)Ga(1-x)N restricts the necessary electrical path between the analyzed area and the instrument ground potential resulting in surface charge accumulation. Consequently,...

The relationship between photoemission spectra of high-Tc cuprates and their therPreprint submitted to Elsevier Science 6 February 2008 modynamic and transport properties are discussed. The doping dependence of the expected quasi-particle density at the Fermi level (EF) are compared with the electronic specific heat coefficient γ and that of the spectral weight at EF with the in-plane and out-o...

In this study, melt-spun Finemet ribbons were coated by a thin layer of SiO2 using dip coating method. Amorphous ribbon prepared by melt spinning method and dip coating were done by using a solution of tetraethylen orthosilicate as a SiO2 precursor, ethanol as solvent and distilled water for hydrolysis. Different thicknesses of SiO2 layer, namely 304, 349, 451, 526 and 970 nm were obtained prop...

Molybdenum thin films with 50 and 150 nm thicknesses were deposited on silicon substrates, using DC magnetron sputtering system, then post-annealed at different temperatures (200, 325, 450, 575 and 700°C) with flow oxygen at 200 sccm (standard Cubic centimeter per minute). The crystallographic structure of the films was obtained by means of x-ray diffraction (XRD) analysis. An atomic force micr...

A network model that investigates electrical resistivity and capillary pressure curves of oil/water/rock systems for a full̄ooded cycle (primary drainage, imbibition and secondary drainage) is presented. This model uses a realistic pore geometry in the form of a grain boundary pore (GBP) shape and pore constrictions. The model also incorporates pore-scale displacement mechanisms and pore-scale w...

In this study we report on the sintering behavior, microstructure and electrical properties of Al-doped ZnO ceramics containing 0-0.2 wt. % graphene sheets (AZO-GNSs) and processed using spark plasma sintering (SPS). Our results show that the addition of <0.25 wt. % GNSs enhances both the relative density and the electrical resistivity of AZO ceramics. In terms of the microstructure, the GNSs a...