The effect of inlet humidity conditions and inclination angle on the air side thermal hydraulic performance of a brazed aluminum heat exchanger has been investigated experimentally. The crossflow heat exchanger had flat tubes and folded fins with fin and louver pitch of 2.1 mm and 1.4 mm, respectively. The glycol temperature was held nearly isothermal at 1C, while humidity of the 12C inlet air ...

The present study investigated the effect of distilled-water/ silver nanofluid on heat transfer in a closed cooling system of one of the electrical energy generation units at Isfahan power plant. The difference between this study and previous researches refers to silver properties which have a high thermal conductivity and is non-toxic, hydrophilic and eco-friendly. Distilled water/ silver ...

In the Compressed Air Energy Storage (CAES) approach, air is compressed to high pressure, stored, and expanded to output work when needed. The temperature of air tends to rise during compression, and the rise in the air internal energy is wasted during the later storage period as the compressed air cools back to ambient temperature. The present study focuses on designing an interrupted-plate he...

A numerical and experimental investigation of flow and heat transfer in a gas- liquid Thermosyphon Heat Exchanger "THE" with built in heat pipes and aluminum plate fins for moderate Reynolds numbers has been carried out. It's module is composed of 6 rows and 15 columns copper pipes with aluminum plate fins with dimensions of 130cm height, 47cm width and  20cm depth. The tubes have been fill...

Air pre-cooling equipment is normally being employed in air-conditioning systems for pre-cooling the ambient outdoor air to enhance the air-conditioning systems performance. In this study, the potential of a passive water-to-air heat pipe based heat exchanger (HPHEX) for air pre-cooling purpose in air-conditioning systems for the high cooling load demanding regions of Iran was investigated. To ...

An investigation of heat recovery for power generation using an absorption-Rankine cycle with a low temperature waste heat source was conducted. In such a cycle, the condenser and boiler of a conventional Rankine system are replaced with an absorber and desorber. A recuperative solution heat exchanger is also incorporated between the absorber and desorber to minimize the external heat input. An...

Leakage in heat exchanger tubes can result in unreliable products and dangerous situations, which could cause great economic losses. Along with fast development of modern acoustic detection technology, using acoustic signals to detect leakage in heat exchange tube has been gradually accepted and considered with great potential by both industrial and research societies. In order to further advan...

In the present study, the ice slurry refrigeration system with pre-cooling heat exchanger (ISSH) is studied experimentally to achieve the system performance, ice crystal formation time and the temperature of ice crystal formation. The operating parameters considered in this paper include the concentration of salt solution, suction pressure, discharge pressure and Energy Efficiency Ratio (EER). ...

The paper presents two methods that are aimed at detecting fouling in cross-flow heat exchangers under normal operating conditions, using measurements that can easily be obtained, i.e. inlet and outlet temperatures and the mass flows of the hot and cold fluids. The methods are a) a physical method that is based on number of transfer units (NTU) relations and b) a black box model that is estimat...

A laboratory-scale temperature system for Control and Automation courses is presented. The system is a coupled two-input two-output process which use peltier modules for temperature control. This paper describes the laboratory-scale system in details. A linear dynamic model of the thermoelectric cooler including the heat sink and the cooling-load heat exchanger is developed and experiments are ...