In our previous paper, particle and temperature segregations in a fluidized bed of binary particle mixtures were experimentally examined, and heat transfer in the segregated fluidized bed was investigated. As the results, it was shown that the temperature segregation results mainly from low heat transfer coefficient through the interface layer, which exists between the flotsam-rich and jetsam-r...

Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

Turbulent heat transfer in Helically Corrugated Tubes (HCT) was numerically investigated for pure water and SiO2 nanofluid using Computational Fluid Dynamics (CFD). This study was carried out for different corrugating pitches (5, 7, 8 mm) and heights (0.5, 0.75, 1.25 mm) at various Reynolds numbers ranging from 5000 to 13300. The effect of nanoparticles on heat transfer augmentation for plain t...

We minimize, with respect to the cross sectional area, the mass of a bar given the rate of heat transfer. The bar enhances the heat transfer surface of a larger known mass to which the bar is attached. This article is an extension of a previous publication by two coauthors, where heat transfer from the sides of the bar was neglected and only conduction through its length was considered. The rat...

jet impingement heat transfer is an effective and practical approach that is employed in many industrial processes where heating, cooling, or drying is required. details of the heat or mass transfer rate have been investigated both experimentally and numerically and can be found in the published literature. in most of the numerical studies, control-volume approach has been employed to solve the...

an irreversible stirling heat pump cycle using ferromagnetic materials as a cyclic working substance is established. the influences of finite-rate heat transfer, heat leak, regeneration time, regenerative lossand the internal irreversibility on the cyclic performance of magnetic heat pumps are taken into account. on the basis of the thermodynamic properties of ferromagnetic materials, the perfo...

In order to examine the laminar convective heat transfer of nanofluid, experiments carried out using silver-oil nanofluid in a concentric annulus with outer constant heat flux as boundary condition. Silver-oil nanofluid prepared by Electrical Explosion of Wire technique and observed no nanoparticles agglomeration during nanofluid preparation process and carried out experiments. The average size...

In heat exchangers, an incompressible fluid is heated initially and cooled at the boundary. The goal to transfer boundary as efficiently possible. this paper we study a related steady version of problem where steadily stirred uniformly in interior on For given large P\'eclet number, how should one stir minimize some norm temperature? This was previously studied by Marcotte, Doering et\ al.\ (SI...

A R T I C L E I N F O Radiator, Overall Heat transfer rate, Genetic Algorithm, Spacing ratio Received July 2013 Accepted July 2013 Available online December 2013 The present work aims at maximizing the overall heat transfer rate of an automobile radiator using Genetic Algorithm approach. The design specifications and empirical data pertaining to a rally car radiator obtained from literature are...