The hot deformation behavior and rolling based on the processing map of a nano-Y2O3 addition near-? titanium alloy were investigated. isothermal compression tests conducted at various temperatures (950?–1070 °C) strain rates (0.001–1 s?1), up to true 1.2. flow stress was strongly dependent temperature rate, decreasing with increased decreased rate. average activation energy 657.8 kJ/mol 405.9 i...

The initial austenite grain size of boron microalloyed steel with three different amounts of boron (20, 40, and 60 ppm) was investigated under different heating temperatures (1150, 1100, and 1050 °C), and hot compression tests of samples in a wide range of temperature (900–1100 °C) and strain rate (0.1–10 s−1) were conducted. It was found that the initial austenite grain size increases with inc...

In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...

A physically-based two-site mean field model has been developed to describe the microstructural evolution due to recrystallization during and after deformation. The model has been applied to predict the recrystallized fraction, recrystallized grain size, and flow stress of 304L austenitic stainless steel during discontinuous dynamic recrystallization (DDRX), post-dynamic recrystallization (PDRX...

Purpose: A study on the hot deformation behaviour and dynamic structural processes (dynamic precipitation operating during deformation at elevated temperatures) of nickel based superalloy was presented. Design/methodology/approach: Compression tests were carried out on precipitations hardenable nickel based superalloy of Inconel 718 at constant true strain rates of 10-4, 4x10-4s-1 within a temp...

In this paper, a ground-based SAR interferometry technology was used to monitor major engineering. This technology has been recognized as a powerful tool for terrain monitoring and structural change detecting. Deformation monitoring for large project has been a hot issue among them. According to GBSAR interferometry principle and characteristics of IBIS system, the authors analysis the error so...

Decades of research has been focused on improving the high-temperature properties of nickel-based superalloys, an essential class of materials used in the hot section of jet turbine engines, allowing increased engine efficiency and reduced CO2 emissions. Here we introduce a new 'phase-transformation strengthening' mechanism that resists high-temperature creep deformation in nickel-based superal...

In this paper, a ground-based SAR interferometry technology was used to monitor major engineering. This technology has been recognized as a powerful tool for terrain monitoring and structural change detecting. Deformation monitoring for large project has been a hot issue among them. According to GBSAR interferometry principle and characteristics of IBIS system, the authors analysis the error so...

The deformation behavior of homogenized Al-7.5Zn-1.5Mg-0.2Cu-0.2Zr alloy has been studied by a set of isothermal hot compression tests, which were carried out over the temperature ranging from 350 °C to 450 °C and the strain rate ranging from 0.001 s-1 to 10 s-1 on Gleeble-3500 thermal simulation machine. The associated microstructure was studied using electron back scattered diffraction (EBSD)...