Underground coal mining activities are prone to cause movement and breakage in geological strata and also lead to mining subsidence and even ground fissures. Along the direction working panel advancing, ground fissures may occur in roof in front and/or behind working panel. However, the investigations of previous similarity tests in lab only emphasize on the region behind working panel. By impr...

We propose a general framework for determining optimal relationships for tensile strength of doubly convex tablets under diametrical compression. This approach is based on the observation that tensile strength is directly proportional to the breaking force and inversely proportional to a non-linear function of geometric parameters and materials properties. This generalization reduces to the ana...

This study evaluated the efficiency of air abrasion alone and associated with phosphoric acid etching on tensile bond strength of a single-bottle adhesive/indirect composite restorative system (Bond 1/Alert) to human enamel. Forty enamel surfaces from extracted human third molars were assigned to 4 groups (n= 10). Mach 4.1 (Kreativ Inc.) air abrasion equipment was used for 20 s. A special syste...

An indirect J-integral technique for measuring the tension softening curve of non-yielding materials like concrete is presented and is applied to mortars reinforced with various short fiber types (steel and synthetic). The tension softening curve serves to characterize and measure material fracture resistance. The dependence of structural behavior on material fracture resistance is investigated...

Melanin, a kind of well-known multifunctional biomacromolecules that are widely distributed in natural sources. In this work, polyurethane (PU)/melanin nanocomposites with enhanced tensile strength and toughness were successfully fabricated via in situ polymerization. It was found that the tensile strength (σ), elongation-at-break (εmax), and toughness (W) were improved from 5.6 MPa, 770%, and ...

The influence of martensitic microstructure and prior austenite grain (PAG) size on the mechanical properties of novel maraging steel was studied. This was achieved by looking at two different martensitic structures with PAG sizes of approximately 40 µm and 80 µm, produced by hot rolling to different reductions. Two ageing heat-treatments were considered: both heat-treatments consisted of auste...

[1] This paper revisits the Arctic Ice Dynamics Joint Experiment (AIDJEX) assumptions about pack ice behavior with an eye to modeling sea ice dynamics. The AIDJEX assumptions were that (1) enough leads were present in a 100 km by 100 km region to make the ice isotropic on that scale; (2) the ice had no tensile strength; and (3) the ice behavior could be approximated by an isotropic yield surfac...

The influence of temperature on the strength properties of structural materials has not been studied in detail yet. In particular, there are the alloys whose dynamic elastic strength demonstrates anomalous growth with the increase of temperature. The spall strength usually shows little change with temperature, i.e. it decreases insignificantly up to 85% of the melting point, which is followed b...

A Fe-34.5 wt % Mn-0.04 wt % C ultra-high Mn steel with a fully recrystallised fine-grained structure was produced by cold rolling and subsequent annealing. The steel exhibited excellent cryogenic temperature properties with enhanced work hardening rate, high tensile strength, and high uniform elongation. In order to capture the unique mechanical behaviour, a constitutive model within finite str...

In this study, effect of transglutaminase (TGase) addition on physical, water barrier, optical and mechanical properties of mechanically deboned chicken meat protein (MDCM-P) films was investigated. When TGase was added to the films, the thickness increased, but the solubility decreased. Films treated with TGase exhibited higher water vapor permeability than control film (p<0.05). When TGase co...