A modified model for predicting the friction force between drill-string and borehole wall under in-plane vibrations was developed. It was found that the frictional coefficient in sliding direction decreased significantly after applying in-plane vibration on the bottom specimen. The friction reduction is due to the direction change of friction force, elastic deformation of surface asperities and...

The Kramers problem in the energy-diffusion limited regime of very low friction is difficult to deal with analytically because of the repeated recrossings of the barrier that typically occur before an asymptotic rate constant is achieved. Thus, the transmission coefficient of particles over the potential barrier undergoes oscillatory behavior in time before settling into a steady state. Recentl...

We describe a new methodology that enables dynamical control of motion through modulating the friction at coating surfaces by exposing to UV light. The principle is based on reversible switching of the surface topographies of the coating by light. The coating surface transfers from flat in the dark to corrugated in the presence of UV by forming regular ridge-like line gratings. Both the static ...

The paper aims at investigating the effects of chemical reaction and thermal radiation on the steady two-dimensional laminar flow of viscous incompressible electrically conducting micropolar fluid past a stretching surface embedded in a non-Darcian porous medium. The radiative heat flux is assumed to follow Rosseland approximation. The governing equations of momentum, angular momentum, energy, ...

This paper aims to present an experimental investigation for optimum tribological behavior (wear depth and coefficient of friction) of electroless Ni-P-Cu coatings based on four process parameters using artificial bee colony algorithm. Experiments are carried out by utilizing the combination of three coating process parameters, namely, nickel sulphate, sodium hypophosphite, and copper sulphate,...

The present experiments provided quantitative results on the static friction coefficient generated by bare foot and foot wearing socks sliding against the tested tiles. Furthermore, the analysis of the test data gave information about the effectiveness of the tested cleaners and detergent. A better knowledge of the parameters which influence friction coefficient would allow the proper selection...

In the present work the influence of a LuGre type friction law [cf. to C. Canudas de Wit, H. Olsson, K.J. Aström, P. Lischinsky, A new model for control of systems with friction, IEEE Transactions on Automatic Control 40 (1995) 419] on the fundamental mechanisms resulting in linear instability of steady sliding in point contacts is investigated. Both a velocity-dependent kinetic friction coeffi...

We have measured the surface topography and calculated the surface roughness power spectrum for an asphalt road surface. For the same surface we have measured the friction for a tire tread compound for velocities 10(-6) m s(-1) < v < 10(-3) m s(-1) at three different temperatures (at -8 °C, 20 °C and 48 °C). The friction data was shifted using the bulk viscoelasticity shift factor a(T) to form ...

[1] Dynamical predictions of landslide runout require measurements of the basal friction. Here we present the first seismically determined bounds on the frictional coefficients for three large volcanic landslides. The three landslides (Bezymianny, Russia 1956, Sheveluch, Russia 1964 and Mount St. Helens, USA 1980) have masses that vary by a factor of 5 and were all followed immediately by erupt...