For high-strength titanium VT1-0, the ultrafine-grained structure of which was obtained by mechanical-thermal treatment using methods helical and longitudinal rolling followed annealing to relieve stress first kind. The effect long-term loading in creep mode at elevated temperature on size shape grains has been studied. A similar study previously carried out for recrystallized coarse-grained tr...

This chapter constitutes an introduction to creep and to the creep response of Aluminium and its alloys. Its major goals are: to provide basic information on creep and its mechanisms to give a description of the more extensively used mathematical relations among creep variables (time, stress and temperature) to illustrate the creep response of pure Aluminium and of Al-Mg alloys to provide a syn...

In this study, a large number of creep tests were carried out to study the effect of stress level and testing temperature on the creep behavior of 63 Sn/37Pb solder in a systematic manner. Based on the dislocation controlled creep mechanism and Gibbs’ free-energy theory, a new creep constitutive model was proposed. The model was found to describe accurately the creep flow of the solder and to b...

From decades Creep has been known and studied for textile materials. In comparison, a newly observed phenomenon of inverse creep seems not to have received much attention. A new instrument has been fabricated to measure creep and inverse creep in textile materials particularly yarns. Creep and Inverse creep measurements of few of the textile yarns like nylon multifilament yarn, Polyester multif...

In tensile tests, ?-Mg/C14–Mg2Ca eutectic alloy with a lamellar structure is plastically deformed above 473 K but ruptures before yielding at temperatures below 423 K. This study investigates the effect of ?/C14 interface on creep strength under 40 MPa stress. The curves exhibited three stages: normal transient stage, minimum creep-rate and accelerating stage. rate was proportional to spacing, ...

The stacking life of corrugated containers under load decreases as relative humidity (RH) increases and when RH cycles, compared with when RH remains stable. Conventional RH test schedules that rely on fixed cycle periods do not adequately reflect the significance of moisture diffusion and hygroexpansion rate phenomena on the creep of corrugated containers and general wood fiber products. With ...

Creep deformation and rupture experiments are conducted on samples of the Ni-base superalloy directionally solidified GTD-111 tested at temperatures between 649°C and 982°C and two orientations (longitudinally and transversely oriented). The secondary creep constants are analytically determined from creep deformation experiments. The classical Kachanov–Rabotnov model for tertiary creep damage i...

This paper characterized bovine extraocular muscles (EOMs) using creep, which represents long-term stretching induced by a constant force. After preliminary optimization of testing conditions, 20 fresh EOM samples were subjected to four different loading rates of 1.67, 3.33, 8.33, and 16.67%/s, after which creep was observed for 1,500 s. A published quasilinear viscoelastic (QLV) relaxation fun...

The creep behavior of bagasse-based composites with virgin and recycled polyvinyl chloride (B/PVC) and high density polyethylene (B/HDPE) as well as a commercial wood and HDPE composite decking material was investigated. The instantaneous deformation and creep rate of all composites at the same loading level increased at higher temperatures. At a constant load level, B/PVC composites had better...

Long term tensile creep studies were conducted on binary NiAl in the temperature range 700-1200 K with the objectives of characterizing and understanding the creep mechanisms. Inverse and normal primary creep curves were observed depending on stress and temperature. It is concluded that the primary creep of NiAl is limited by dislocation mobility. The stress exponent for creep, n, decreased fro...