As refrigeration has become one of the basic needs people of this era. The permanent demand of refrigerator is continuously increases in India and also in the whole world. The energy consumption in the refrigeration is also increases. Approximately it contribute around 13% energy consume in this sector. In the kitchen appliances, only the refrigerator consumes power continuously throughout a da...

This paper presents a cost-effective method to increase the COP and utility of a domestic refrigerator using R-134a refrigerant. A cabin was installed on the top of a domestic refrigerator with condenser coils of refrigerator serving as heating coils inside the cabin. Known quantity of water was heated by the condenser coils (due to convection currents) thereby increasing the overall COP of the...

A multi-effect distillation where the condenser of a high pressure column is integrated with the reboiler of a low pressure column has been studied. The method of selfoptimizing control has been used to provide a systematic procedure for the selection of controlled variables, based on steady-state economics. The system has 10 degrees of freedom at steady state. The heat integrated distillation ...

In most of the Automotive Air Conditioning Systems (AACSs) though the compressor is powered by the car engine, the evaporator blower and the condenser fan are run by a 12-volt DC battery which is powered by an alternator. Any fault in the alternator, drops the battery output voltage. Owing to this, a stationary test rig for an AACS is developed with all actual automotive components. A continuou...

this is a comprehensive review of the recent progresses made in the field of zeolite membranes. it describes zeolitic materials and methods of membrane fabrication, followed by a summary of applications for gas separation, pervaporation and separation of liquid mixtures. special attention is called to polymer mixed matrix membranes (mmms) and membranes based on metal organic frame works (mofs)....

A fully equipped automotive air-conditioning test system consists of 5 main components: a compressor, a condenser, an orifice tube, an evaporator and an accumulator. R-134a is used as refrigerant. The coefficient of performance, evaporator cooling capacity, compressor power consumption, total mass flow rate, vapor mass flow rate, liquid mass flow rate and oil in circulation, pressures and tempe...

In this paper the development of a capacitive microphone with integrated preamplifier is described. The condenser microphone is made by micromachining of polyimide on silicon, and is compatible with CMOS technology. Therefore, the structure can be realised by post processing on substrates containing integrated circuits, independently of the IC process. Microphones with a required DC bias voltag...

The criteria as well as the methods and measurements of wind tunnel simulation on wind effects on air-cooled condensers in a power plant were discussed. The parameter of recirculation was suggested to describe the wind effects on the efficiency of the condenser. The result of practical project models shows that great wind effects of both wind speed and the angle of the incident flow on the effi...

Accurate and optimum usage of energy sources is gaining importance all over the world due to the increase of energy need and limited energy sources. Optimum usage of energy sources is not only necessity for energy conversion systems, but also design and production of energy conversion devices. Therefore optimization of condensers is very important for HVAC systems which require as possible as m...

Equations are derived for the capacity-voltage relations for stimulation of tissue by condenser discharges, using the hypothesis that the local excitatory process p grows under the influence of an applied potential V according to the equation, See PDF for Equation where K and k are constants. It is further assumed that the local excitatory process becomes adequate when it attains a value h +/- ...