The connection between noncentrosymmetric materials’ structure, electronic structure, and bulk photovoltaic performance remains not well understood. In particular, it is still unclear which photovoltaic (PV) mechanisms are relevant for the recently demonstrated visible-light ferroelectric photovoltaic (K,Ba)(Ni,Nb)O3−δ . In this paper, we study the bulk photovoltaic effect (BPVE) of (K,Ba)(Ni,N...

in this paper, the performance evaluation of a two-way hybrid photovoltaic/thermal (pv/t) solar collector was analytically and experimentally carried out. mathematical expressions for operating parameters in glass to glass and glass to tedlar pv/t solar collectors were developed and experimentally validated by a glass to tedlar pv/t solar collector system. also the influence of air flow rate on...

in this paper, the electrical consumption of a research center building is derived of the bills, then with defining of fuzzy bus thermal coefficient objective function for heating, the amount of available heat selling to research center building consumer that is produced by biomass solar hybrid source is calculated. with the capacity determination of biomass solar hybrid source to provide therm...

this paper proposes a new configuration for solar energy conversion systems. one challenging issue of the photovoltaic (pv) systems is partial shading, and in this paper module integrated converters (mic) are used to overcome this problem in pv arrays. a few boost converters are employed as mics to mitigate the shading effect. furthermore, to reduce the cost and to increase the system performan...

In this research, a new phenanthroline derivative was synthesized and characterized on purpose to polymerize the monomer via a Stille-polymerization with different electron donating moieties leading to a range of new wide band gap polymers. The novelty in this monomer would be the long side chains in order to ensure the solubility of the entire polymer. Hence there would be no necessity for the...

Abstract: This paper proposes a new analysis method for photovoltaic (PV) modules. The main objectives are to obtain the resistance parameters of PV modules by adjusting I-V equation and voltage equation of diode and to find the relationship between resistance parameters and power. Firstly, values of serial resistance and parallel resistance at maximum power point are concluded. Secondly, the c...

in this article using comparative multi-purpose algorithm of pso, optimum capacity of new resources and their spinning storage is defined. spinning reserve requirements and optimized to maximize profit per unit is determined according to uncertainty. in fact by increasing the level of cost reservation, power supply increases but penalty of blackout decreases. in this paper in has been tried to ...

Semiconductor devices with enhanced efficiency, resilience, and/or optimized to specific applications/environments rely increasingly on the incorporation of III-V random alloys that have been engineered to possess certain required optoelectronic properties. When these materials are grown, however, challenges with non-random elemental arrangements can greatly affect – and in some cases eliminate...

Water-based polymer nanoparticle dispersions (solar paint) offer the prospect of addressing two of the main challenges associated with printing large area organic photovoltaic devices; namely, how to control the nanoscale architecture of the active layer and eliminate the need for hazardous organic solvents during device fabrication. In this paper, we review progress in the field of nanoparticu...

Articles you may be interested in High efficiency sequentially vapor grown n-i-p CH3NH3PbI3 perovskite solar cells with undoped P3HT as p-type heterojunction layer Carrier recombination losses in inverted polymer: Fullerene solar cells with ZnO hole-blocking layer from transient photovoltage and impedance spectroscopy techniques High efficiency double heterojunction polymer photovoltaic cells u...