Most current pollution management in cities is based on treating pollution at the end-of-the pipe, after pollution is generated. This paradigm worked well for treating municipal sewage and industrial effluents – point sources of pollutants. Pollution from these sources has been greatly reduced since passage of the Clean Water Act in 1972. However, the remaining pollution problem in post-industr...

In this investigation, a flow rate estimation guided wave based scheme in pipes is proposed. The effect of the fluid over the propagation of longitudinal waves has been experimentally studied by using several laminar flows of water transported by a steel pipe. Results have shown a decrease of the guided wave pattern repeatability and the signal energy as the flow rate increase as a result of th...

Laminar and turbulent pipe flow of a ferrofluid with an imposed linearly polarized, oscillating, magnetic field is examined here. Experimental results show a fractional pressure drop dependence on flow rate, magnetic field strength, and oscillation frequency. Calculations are presented, which show that ferrofluid theory can explain the flow phenomena in laminar and turbulent pipe flow. The mode...

Temperature fluctuation in fluid causes high cycle thermal fatigue in shroud structure according to its amplitude and frequency. There are still some incidents of thermal fatigue and leakage in light water reactors (Japanese PWR Tomari-2 in 2003, French PWR CIVAUX in 1998), and also in sodium cooled reactors (French FBR PHENIX in 1992). Mixing tee is a typical component where temperature fluctu...

This paper focuses on simulations of enclosed air pocket movements in conjunction with bottom outlet operations. The critical velocity of water for air pocket transport in pipe is the minimal flow velocity for the air pocket start to move downstream. A numerical model is developed to simulate the critical velocity of air pocket transport in pipe flow and to discuss the impacts of tunnel slope, ...

the incorporation of several anti-rodent masterbatches into polyethylene (pe) granules used for gas pipes and the effects of the masterbatches on the physical properties of the pipes were studied. four commercial anti-rodent masterbatches from different international companies including, clariant, alchemix, polyone, and newgen were used in this research. each of the masterbatch was primarily dr...

The single-phase flow and thermal performance of a double pipe heat exchanger are examined by experimental methods. The working fluid is water at atmospheric pressure. Temperature measurements at the inlet and outlet of the two streams and also at an intermediate point half way between the inlet and outlet is made, using copper-constantan thermocouple wires. Mass flow rates for each stream are ...

Two different tools, the non-empirical resolvent analysis and the data-based dynamic mode decomposition, are employed to assess the changes induced by transpiration in the dynamics of a turbulent pipe flow. The focus is on very large-scale motions. Both analyses permit the observation of streamwise waviness in the large flow structures and how the transpiration can inhibit fluctuation in locali...

Liquid Natural Gas (LNG) processing facilities contain large complex networks of pipes of varying diameter and orientation intermixed with control valves, processes and sensors. Regular inspection of these pipes for corrosion, caused by impurities in the gas processing chain, is critical for safety. Popular existing non-destructive technologies that used for corrosion inspection in LNG pipes in...

The spring-driven ball-type check valve is one of the most important components of hydraulic systems: it controls the position of the ball and prevents backward flow. To simplify the structure, the spring must be eliminated, and to accomplish this, the flow pattern and the behavior of the check ball in L-shaped pipe must be determined. In this paper, we present a full-scale model of a check bal...