Hip joint simulators have been largely used to assess the wear performance of joint implants. Due to the complexity of joint movement, the motion mechanism adopted in simulators varies. The motion condition is particularly important for ultra-high molecular weight polyethylene (UHMWPE) since polyethylene wear can be substantially increased by the bearing cross-shear motion. Computational wear m...

The importance of friction and wear control cannot be over emphasized for economic reasons and longterm reliability. The savings can be substantial, and these savings can be obtained without the deployment of investment. Tribology is crucial to modern machinery which uses sliding and rolling surfaces. This article describes the tribological behavior analysis for the conventional materials i.e. ...

An investigation was carried out to understand the effects of solidification time of the cylindrical specimen on hardness, wear rate and the coefficient of friction of Aluminium alloy (LM4). The commercially available LM4 Aluminium alloy was melted in a crucible furnace under argon atmosphere. The molten metal was poured into sand moulds having dissimilar size holes. The cast rods were tested f...

Bearing surface wear in total joint replacements arises from local stresses that exceed the mechanical strength of the articulating materials. Because both the tensile/compressive principal stresses and maximum shear stress near the bearing surface increase when contact stresses increase, minimizing contact stresses has been a central design goal, especially in total knees. Wear rates increase ...

In this work, wear behavior and microstructural characterization of porous layers produced in glass-ceramic substrates by pulsed laser irradiation in the nanosecond range are studied under unidirectional sliding conditions against AISI316 and corundum counterbodies. Depending on the optical configuration of the laser beam and on the working parameters, the local temperature and pressure applied...

In the metal cutting process, the friction and wear behavior between the cutting tool and machined surface is the most important factor that affects the surface quality and the service life of the cutter. The irregular pore structure of porous titanium alloy has changed its mechanical properties and the processing technology. The friction and wear mechanism of the cutting tool and the machined ...

The unidirectional rotary and reciprocating sliding experiments of the 40Cr pin/GCr15 disc tribo-pair were carried out on MFT-5000 Rtec friction wear tester under same test conditions with a speed 0.2 m/s load 150 N. Compared sliding, in exhibits stabler coefficient better resistance. By analyzing surface morphologies two pins, main mechanism was found to be adhesive wear. For tribo-layer pin m...