A study was made to determine the effects of temperature and moisture on the D-value of a common biological indicator. Relative humidity (RH) was varied between 10 and 70% in increments of 10%, and temperature was varied between 30 and 70 degrees C in increments of 10 degrees C. Temperature was found to have a pronounced effect on the D-value. At 60% RH, the D-value varied from 15.0 min at 30 d...

in the present work, the effect of aluminum content, austenitizing temperature and austempering time and temperature on the mechanical properties and hardness of fe-c-al grey cast iron was investigated. for this purpose, three alloys containing 1, 2 and 4 weight percent of aluminum were provided. the tensile samples were austenitized at 850?c and 900?c for 120 min, followed by austempering proc...

We have derived azimuthally-averaged radial temperature profiles of the X-ray gas contained within 11 clusters of galaxies with redshift z = 0.03−0.2 observed with BeppoSAX. Each of the 11 clusters have had their radial temperature profiles previously determined with ASCA. We find that the temperature profiles of these clusters are generally flat or increase slightly out to ∼30% of the virial r...

The purpose of this study was to characterize the deformation properties of a range of long-term denture soft lining materials using dynamic mechanical thermal analysis. Specimens were subjected to sinusoidal shear deformation at a frequency of 1 Hz and a strain of 64 microns peak to peak over a temperature range of 30-70 degrees C. The technique simulated the type and rate of deformation soft ...

We have measured the temperature-dependent thermal conductivity k(T) of crystalline ropes of singlewalled carbon nanotubes from 350 K to 8 K. k(T) decreases smoothly with decreasing temperature, and displays linear temperature dependence below 30 K. Comparison with electrical conductivity experiments indicates that the room-temperature thermal conductivity of a single nanotube may be comparable...

The ablation and oxidation of ZrB₂-based ultra high temperature ceramic (UHTC) composites containing 10%, 15% and 30% v/v SiC were tested under different heat fluxes in a high frequency plasma wind tunnel. Performance was significantly affected by the surface temperature, which was strongly dependent on the composition. Composites containing 10% SiC showed the highest surface temperature (>2300...

Silicon micro-hole arrays (Si-MHA) were fabricated as a gas diffusion layer (GDL) in a micro fuel cell using the micro-electro-mechanical-systems (MEMS) fabrication technique. The resistance temperature detector (RTD) sensor was integrated with the GDL on a bipolar plate to measure the temperature inside the fuel cell. Experimental results demonstrate that temperature was generally linearly rel...

BACKGROUND Electrode cooling by circulating fluid within the electrode (closed loop) or open irrigation facilitates radiofrequency (RF) ablation. This study compared lesion parameters between closed loop and open irrigation with the use of a canine model. METHODS AND RESULTS In 8 anesthetized dogs, the skin over the thigh muscle was incised and raised, forming a cradle superfused with heparin...