The problem of detecting a shift in the percentile of a Birnbaum–Saunders population in a process monitoring situation is considered. For example, such problems may arise when the quality characteristic of interest is tensile strength or breaking stress. The parametric bootstrap method is used to develop a quality control chart for monitoring percentiles when process measurements have a Birnbau...

Ambient and cryogenic surface mechanical attrition treatments (SMAT) are applied to bcc iron plate. Both processes result in significant surface grain refinement down to the ultrafine-grained regime; the cryogenic treatment results in a 45% greater grain size reduction. However, the refined region is shallower in the cryogenic SMAT process. The tensile ductility of the grain size gradient remai...

In this study, some mechanical properties of borided and unborided four steels were investigated. Boronizing of steels was performed by powder pack method at 1210 K for 4 h. The hardness of borides, boride layer thickness and room temperature tensile properties were measured and it was observed that hardness and tensile properties strongly depend on chemical composition of steels. In addition, ...

nowadays, soil reinforcement using polymer elements have been investigated by a number of researchers in order to increase the load capacity of soils. reinforcing soils using fibers is a method of soil improvement, which offers a homogenous mixture in combination with soils, regarding their tensile strength. this combination maintains pressure loading capacity and properties in mutual resistant...

This investigation is concerned to evaluate the influence of heat treatment on mechanical behavior of AISI1040 steel; it is one of the grades of medium carbon steel of American standard containing 0.40% carbon in its composition. Specimen of quenched/hardened AISI1040 steel was tempered at temperature (650,450&250°C) for 60, 90&120 minutes to modify desired properties. The mechanical behavior, ...

The fatigue behavior of a Ceramic Matrix Composite (CMC) at intermediate temperature under air is investigated. Because of the low density and the high tensile strength of CMC, they offer a good technical solution to design aeronautical structural components. The aim of the present study is to compare the behavior of this composite under static and cyclic loading. Comparison between incremental...

Dynamic mechanical analysis (DMA) was used to characterize biomedical composites consisting of synthetic hydroxyapatite (HA) particulate reinforced polyethylene (PE). The effects of the HA volume fraction, temperature and HA particle on the storage modulus (E(I)) and damping (tan delta) were investigated. Increasing HA volume fractions increased E(I) and decreased tan delta. E(I) was found to b...

This work investigated the microstructure and elevated-temperature (400-475C) tensile and tensile-creep deformation behavior of a powder metallurgy (PM) rolled Ti-6Al-4V-1B(wt.%) alloy. The PM rolled Ti-6Al-4V-1B alloy exhibited a duplex microstructure, and it did not exhibit a strong α-phase texture compared with the PM extruded Ti-6Al-4V-1B alloy. The PM rolled Ti6Al-4V-1B alloy exhibited gre...

Tensile test on smooth and circumferentially notched specimens, systematic observation of fracture surfaces and large deformation finite element analysis were conducted to understand the deformation and failure behavior of a magnesium alloy (AM60). The plastic deformation is considered to be dominated by twining mediated slip. The tensile properties were not sensitive to the strain rates applie...

The goal of the present research is to develop a better understanding of the tensile response of open-cellular aluminum 6061 T6 alloy. Both tensile and compression samples of this metallic foam were tested under constant strain rate conditions at 293, 423, and 523 K. Scanning electron microscopy was performed on individual struts to assess the modes and mechanisms associated with fracture. Theo...