Investigation of the tensile and fatigue properties of cast magnesium alloys, created by the heated mold continuous casting process (HMC), was conducted. The mechanical properties of the Mg-HMC alloys were overall higher than those for the Mg alloys, made by the conventional gravity casting process (GC), and especially excellent mechanical properties were obtained for the Mg97Y2Zn1-HMC alloy. T...

Nutrient conduit networks can be introduced within the Polyethylene Glycol Diacrylate (PEGDA) tissue construct to enable cells to survive in the scaffold. Nutrient conduit networks can be created on PEGDA by macrochannel to nanochannel fabrication techniques. Such networks can influence the mechanical and cell activities of PEGDA scaffold. There is no study conducted to evaluate the effect of n...

A duplex microstructure consisting of allotriomorphic ferrite and austenite at ambient temperature, has been produced in a low–alloy steel, by a simple heat treatment which involves intercritical annealing followed by quenching. The tensile properties obtained are good, with a total elongation of some 28% at an ultimate tensile strength approaching 900MPa. The form of the stress versus strain c...

Tensile stress-strain curves a r e obtained at s t rain rates of %lo-'+, ~ 1 0 and c1000/s for carbon, Kevlar and glass fibre woven-reinforced polyester resin compos i tes and the variation of modulus, tensile strength and fracture strain with strain rate is determined. A change in the failure mode at the highest strain rates is observed for the glass but not the carbon or Kevlar reinforced com...

Numerical simulations of sheet metal forming processes need the establishment of highly reliable results, which in turn need the accurate identification of mechanical properties. In this paper a study is presented on the choice of the characterization function of flow stress-strain curve of sheet metal materials, as well as the selection of the best yield locus, based on experimental uniaxial t...

In this investigation, a laser cladding process with a powder feeding was used to deposit stainless steel 410L (high strength, excellent resistance to abrasion and corrosion, and great laser compatibility) onto railhead (higher strength, heat treated hypereutectoid rail grade manufactured in accordance with the requirements of European standard EN 13674 Part 1 for R400HT grade), to investigate ...

BACKGROUND This study used the 3D finite element method to investigate canine's displacements and stresses in the canine's periodontal ligament (PDL) during canine's translation, inclination, and rotation with transparent tooth correction treatment. METHODS Finite element models were developed to simulate dynamic orthodontic treatments of the translation, inclination, and rotation of the left...

The performance of the grouted sleeve lapping connector that is used to connect reinforcement bars in a precast concrete structure is studied. A total of 63 specimens, varying in bar diameter and lap length, were tested under tensile load. The failure modes, ultimate tensile strength values and load-displacement curves of the specimens are discussed in the study. Two equations are proposed for ...

Neutron diffraction analysis was employed to measure residual stresses near welds in used anhydrous ammonia nurse tanks. Tensile residual stresses contribute to stress corrosion cracking of nurse tanks, which can cause tanks to release toxic ammonia vapor. The analysis showed that tensile residual stresses were present in the tanks measured, and the magnitudes of these stresses approached the y...