In this paper, wire electric discharge machining (WEDM) of Titanium alloy (Ti-4.5Al-2V) is studied. In WEDM, the prime objective in cutting operation is to achieve the highest possible cutting speed along with desirable surface finish without sacrificing productivity. It is evident that a high material removal rate and a very good surface finish can never be achieved simultaneously in WEDM. Sel...

Selection of Quarter Horses for different purposes has led to the formation of lines, including racing and cutting horses. The objective of this study was to identify genomic regions divergently selected in racing line of Quarter Horses in relation to cutting line applying relative extended haplotype homozygosity (REHH) analysis, an extension of extended haplotype homozygosity (EHH) analysis, a...

One of the big challenges in machining is replacing the cutting tool at the right time. Carrying on the process with a dull tool may degrade the product quality. However, it may be unnecessary to change the cutting tool if it is still capable of continuing the cutting operation. Both of these cases could increase the production cost. Therefore, an effective tool conditionmonitoring systemmay re...

Lianas are an important component of tropical forests, where they reduce tree growth, fecundity, and survival. Competition for light from lianas may be intense; however, the amount of light that lianas intercept is poorly understood. We used a large-scale liana-removal experiment to quantify light interception by lianas in a Panamanian secondary forest. We measured the change in plant area inde...

Surface roughness is a result of the cutting parameters such as: cutting speed, feed per tooth and the axial depth of cut, also the tool’s geometry, tool’s wear vibrations, etc. Moreover, the surface finish influences mechanical properties such as fatigue behaviour, wear, corrosion, lubrication and electrical conductivity and the combination of cutting parameters influence the power consumption...