In this paper, we propose a level shifter circuit capable of handling a wide input voltage range. The circuit is based on a conventional two-stage comparator, and has a distinctive feature in that it operates a current amplification scheme for ultra low-power operation. The proposed circuit can convert low-voltage input digital signals into high-voltage output digital signals. The circuit achie...

This paper is focused on how to implement a nonlinear voltage divider used in the electrical power network disturbances measurement system preconditioning circuit. The voltages acquired from the electrical power network have amplitudes between 0.2 kV and 10 kV, values which are very high for an acquisition board. These amplitudes must be reduced to the values accepted by the acquisition boards:...

The advantage of this method involves controlling the flow of current through all the connections – especially those used to measure the voltage. The measurement current flows through one set of connections, usually those that are farthest apart. If these connections are resistive (i.e., the connections are poor) there will be significant voltage drop across them. However, this voltage drop doe...

A threshold-voltage-shift compensation and suppression method for active matrix organic light-emitting diode (AMOLED) displays fabricated using a hydrogenated amorphous silicon thin-film transistor (TFT) backplane is proposed. The proposed method compensates for the threshold voltage variation of TFTs due to different threshold voltage shifts during emission time and extends the lifetime of the...

This paper presents the design of a low cost voltage controller of a single phase Self-Excited Induction Generator (SEIG). The control scheme is based on the measurement of users load voltage and controlling the dump load power using an Analogue Input Power Controller (AIPC). The controller output varies from 2 -10V and it controls the output AC power going to a resistive dump load. A PI type c...

This paper presents an optimization of the voltage doubler stages in an energy conversion module for Radio Frequency (RF) energy harvesting system at 900 MHz band. The function of the energy conversion module is to convert the (RF) signals into direct-current (DC) voltage at the given frequency band to power the low power devices/circuits. The design is based on the Villard voltage doubler circ...

It is practically not feasible to measure the open-loop voltage gain of the operational amplifier in the open loop configuration. It is because the open-loop voltage gain of the operational amplifier is very large. In order to avoid the saturation of the output voltage, a very small input should be given to operational amplifier which is not possible to be measured practically by a digital mult...

Electrostatic force measurement at the micro/nano scale is of great significance in science and engineering. In this paper, a reasonable way of applying voltage is put forward by taking an electrostatic chuck in a real integrated circuit manufacturing process as a sample, applying voltage in the probe and the sample electrode, respectively, and comparing the measurement effect of the probe osci...

The main frequency is an important parameter of an electrical power system. The frequency can change over a small range due to generation-load mismatches. Some power system protection and control applications, e.g., frequency relay for load shedding, load-frequency controller, require accurate and fast estimation of the frequency. Most digital algorithms for measuring frequency have acceptable ...

A novel method is presented for online estimation of the junction temperature (Tj) of semiconductor chips in IGBT modules, based on the voltage drop (VEE’) across the parasitic inductor that exists between the main emitter (E) and auxiliary emitter (E’) terminals. The peak amplitude of the voltage drop (VEE’) was found to depend on the junction temperature at a known current and DC link voltage...