نتایج جستجو برای: accelerated corrosion
تعداد نتایج: 92636 فیلتر نتایج به سال:
A cyclic wet/dry accelerated corrosion test was used to compare the corrosion behavior of medium-Mn steel and Q345 steel. In terms of scanning electron microscope (SEM), using X-ray diffraction (XRD), electron probe microanalysis (EPMA), X-ray photoelectron spectroscopy (XPS), and analysis of the corrosion process, the results showed that the medium-Mn steel did not exhibit higher corrosion res...
thermal barrier coatings (tbcs) are used to provide thermal insulation to the hot section components of gas turbines in order to enhance the operating temperature and turbine efficiency. hot corrosion and thermal shocks are the main destructive factors in tbcs which comes as a result of oxygen and molten salt diffusion into the coating. in this thesis atmospheric plasma spraying was used to dep...
We report here on the mechanisms underlying the corrosion of weathering steel in accelerated laboratory tests using artificially polluted SO2-atmospheres. The role of corrosion parameters such as the SO2 concentration, the exposure time, the relative humidity and temperature of the environment are discussed in detail. Through the extensive use of Mössbauer spectroscopy in both its transmission ...
Corrosion is one of the main causes affecting durability of structures. Corrosion effects on structures cannot be ignored and replaced. To understand the performance of structures there is a need to study the rate at which different corrosion levels occur. Hence the present investigation has been taken up to study the behaviour of NBS (National Bureau of Standard) beam specimens made up of Ordi...
To improve the corrosion protection provided to prestressing strands, anti-bleed grouts are used to fill voids in post-tensioning ducts that result from bleeding and shrinkage of older portland cement grouts. Environmental differences caused by exposing the strands to dissimilar grouts, however, have the potential to cause rapid corrosion. Portland cement grout, gypsum grout, and four commercia...
The corrosion behavior of pure Fe under a Na₂SO₄ deposit in an atmosphere of O₂ + H₂O was investigated at 500 °C by thermo gravimetric, and electrochemical measurements, viz. potentiodynamic polarization, electrochemical impedance spectroscopy (EIS), and surface characterization methods viz. X-ray diffraction (XRD), and scanning electron microscope (SEM)/energy dispersive spectroscopy(EDS). The...
The corrosion of steel reinforcement in an aging highway infrastructure is a major problem currently facing the transportation engineering community, in particular bridge engineers. In the United States, maintenance and replacement costs are measured in billions of dollars. Further, the use of deicing salts has resulted in steady deterioration of bridge decks due to corrosion. These concerns ha...
The Canadian Journal of Chemical Engineering, Volume 81, February 2003 Complex flows with boundary layer separation and reattachment commonly occur in situations of practical interest. In such flows, any accompanying heat or mass transfer is strongly influenced by the fluid dynamics. For example, rates of heat or mass transfer to the wall can have large variations in the reattachment region. In...
As one of the main products produced by oral microorganisms, the role of lactic acid in the corrosion of titanium is very important. In this study, the corrosion behavior of titanium in artificial saliva with and without lactic acid were investigated by open-circuit potentials (OCPs), polarization curves and electrochemical impedance spectroscopy (EIS). OCP firstly increased with the amount of ...
hen the first trivalent chromium electroplating process was commercially introduced in the mid-l970s, information on the corrosion properties of the deposits and other physical properties was unknown. To obtain a comprehensive understanding about the corrosion properties of trivalent chromium electrodeposits over a variety of nickel deposits, chromium deposits from trivalent chromium electrolyt...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید