background and aims. anterior esthetic restoration is challenging in pediatric dentistry, due to limited durability and poor retention of the restoration.this study assessed the effect of air abrasion on tensile failure load of composite class iii restorations using different preparation techniques. materials and methods. 100 extracted human anterior primary teeth were divided, based on the pre...

OBJECTIVE To assess microleakage in conservative class V cavities prepared with aluminum-oxide air abrasion or turbine and restored with self-etching or etch-and-rinse adhesive systems. MATERIALS AND METHODS Forty premolars were randomly assigned to 4 groups (I and II: air abrasion; III and IV: turbine) and class V cavities were prepared on the buccal surfaces. Conditioning approaches were: g...

OBJECTIVES This study evaluated the influence of air-particle abrasion protocols on the surface roughness (SR) of zirconia and the shear bond strength (SBS) of dual-polymerized resin cement to this ceramic. MATERIALS AND METHODS Sintered zirconia blocks (n = 115) (Lava, 3M ESPE) were embedded in acrylic resin and polished. The specimens were divided according to the 'particle type' (Al: 110 µ...

BACKGROUND Air-abrasion can be used for enamel preparation before fissure sealing as well as acid etching which is the evidence-based method for enamel preparation before sealing. AIM The aim of this study is to evaluate the status of sealed occlusal surfaces of the first permanent molars after one, two, and five years and to compare consequence of using the two different methods for enamel p...

BACKGROUND This study evaluated the effect of air-particle abrasion with different particle sizes on the surface roughness and phase transformation of yttria-stabilized tetragonal zirconia ceramics (Y-TZP). METHODS Eighty-four Y-TZP discs of 15 mm diameter and 1.0 mm thickness were fabricated. The samples were divided into four groups (n = 21): (1) air-particle abrasion with 30 μm CoJet sand ...

The purpose of this study was to evaluate the influence of air-abrasion and subsequent heat treatment on the shear bond strength of the bond between indirect composites and a zirconia material. Four surface preparations were employed; ground flat, then heated to regenerate the crystal phase (C); air-abraded with alumina for 10 s (S10), for 20 s (S20), and air-abraded for 10 s and heated (H). Di...

This study evaluated the efficiency of air abrasion alone and associated with phosphoric acid etching on tensile bond strength of a single-bottle adhesive/indirect composite restorative system (Bond 1/Alert) to human enamel. Forty enamel surfaces from extracted human third molars were assigned to 4 groups (n= 10). Mach 4.1 (Kreativ Inc.) air abrasion equipment was used for 20 s. A special syste...

Air abrasion as a caries removal technique is less aggressive than conventional techniques and is compatible for use with adhesive restorative materials. Alumina, while being currently the most common abrasive used for cutting, has controversial health and safety issues and no remineralisation properties. The alternative, a bioactive glass, 45S5, has the advantage of promoting hard tissue remin...

BACKGROUND AND OBJECTIVE Enormous advances have been made in adhesives; however, the problem of post-operative sensitivity has dragged along. Enough literature exists on the effect of air abrasion over bond strength of composites. However, not much is reported on its relation with microleakage and post operative sensitivity. Therefore, the aim of the study was to compare and evaluate dentinal h...