an artificial neural network (ann) model is developed for the analysis, simulation, and prediction of the austenite reversion in the thermo-mechanical treatment of 304l austenitic stainless steel. the results of the ann model are in good agreement with the experimental data. the model is used to predict an appropriate annealing condition for austenite reversion through the martensite to austeni...

1569-190X/$ see front matter 2011 Elsevier B.V doi:10.1016/j.simpat.2011.10.009 ⇑ Corresponding author. Address: Laboratoire de M 42 27; fax: +33 (0) 4 91 16 44 81. E-mail address: [email protected] (A. Mau This paper describes investigations realised to perform simulations of shoulder milling operations on AISI 304L stainless steel using the commercial software LS-Dyna . A Lagrangian form...

In the work influence of thermal limiters on formation a dendritic structure stainless steel AISI 304L layer deposited by electric arc welding in argon medium was investigated. The billets investigated mode differential interference contrast. analysis obtained structures showed that use form graphite skids allows to obtain uniform without sharp transitions between layers.

The aim of this research is to study the influence of explosive characteristics on the weld interfaces of stainless steel AISI 304L to low alloy steel 51CrV4 in a cylindrical configuration. The effect of ammonium nitrate-based emulsion, sensitized with different quantities and types of sensitizing agents (hollow glass microballoons or expanded polystyrene spheres) and Ammonium Nitrate Fuel Oil ...

The paper deals with the corrosion behavior of stainless steels as candidate materials for biofuel production plants by liquefaction process of the sorted organic fraction of municipal solid waste. Corrosion tests were carried out on AISI 316L and AISI 304L stainless steels at 250 °C in a batch reactor during conversion of raw material to bio-oil (biofuel precursor), by exposing specimens eithe...

aisi 304l austenitic stainless steel with different grain sizes of 0.5 -12 μm was obtained through the martensiticprocess. corrosion behavior of different samples was investigated in a 0.5m hcl solution using open circuitpotential, potentiodynamic polarization and electrochemical impedance spectroscopy tests. also, the correlationbetween the grain size and pitting corrosion resistance was asses...

The aim of this study is to provide a clear and accessible method obtain accurate true-stress strain data, extend the limited material data beyond ultimate tensile strength (UTS) for AISI 304L. 304L used outer construction some types nuclear transport packages, due its post-yield ductility high failure strain. Material UTS throughout literature. 3D digital image correlation (DIC) was during ser...

the cold roll bonding of al on aisi 304l stainless steel was carried out to fabricate the al/304l/al clad sheet composites. the maximum bond strength of 20 n/mm was acquired just by 38% reduction, for which the tearing of the aluminum sheet occurred during the peeling test. the microstructural evolution during subsequent postannealing heat treatment was systematically studied based on the impur...