In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...

This paper presents a series of tests on cold-formed stainless steel bolted connections. The test specimens were fabricated from three different types of stainless steel, including austenitic stainless steel EN1.4301 (AISI 304) and EN1.4571 (AISI 316Ti having small amount of titanium) as well as lean duplex stainless steel EN1.4162 (AISI S32101). The material properties of the three types of st...

This study investigated the effects of cryogenic treatment and tempering temperature applied after on mechanical microstructural properties AISI 431 martensitic stainless steel. After conventional heat (CHT), steel samples were cryogenically treated at -180 °C for 6 hours then tempered 200 (CT200) 300 (CT300) 2 hours. these processes, hardness measurement, tensile test, abrasion test carried ou...

The objective of this paper is to describe and analyze a series of nonlinear finite element analyses used to compare three design methods for locally slender, braced, steel beams and columns. The three design methods are: (i) the hot-rolled steel AISC Specification, (ii) the coldformed steel AISI Specification which uses the effective width method throughout, and (iii) the cold-formed steel Dir...

In this research work, investigations are carried out on Continuous Wave (CW) Nd:YAG laser welding system after preliminary experimentation to understand the influencing parameters associated with laser welding of AISI 304. The experimental procedure involves a series of laser welding trials on AISI 304 stainless steel sheets with various combinations of process parameters like beam power, beam...

A high quality joint between tool steel and stainless steel alloys is hard to achieve with the conventional welding process. In this study, a new process of joining semi-solid AISI D2 tool steel and AISI 304 stainless steel using a partial remelting method is proposed. Metallographic analysis and Vickers hardness tests were performed. The results obtained from investigating the basic geometries...

In the present work CO2 continuous laser welding process was successfully applied and optimized for joining a dissimilar AISI 316 stainless steel and AISI 1009 low carbon steel plates. Laser power, welding speed, and defocusing distance combinations were carefully selected with the objective of producing welded joint with complete penetration, minimum fusion zone size and acceptable welding pro...

We report on the effect of femtosecond-laser-induced periodic surface structures (LIPSS) on the tribological properties of stainless steel. Uniform periodic nanostructures were produced on AISI 304L (American Iron and Steel Institute steel grade) steel surfaces using an 800-nm femtosecond laser. The spatial periods of LIPSS measured by field emission scanning electron microscopy ranged from 530...

Sol-Gel coatings are a good choice for protection and bioactivation of metals used as dentistry and standard surgical implant materials. These films should both prevent degradation of the substrates by wear or corrosion, and bioactivate the material for inducing the formation of a hydroxyapatite (HA) rich layer onto the material surface, thereby permitting a natural bonding to living tissues. T...