This chapter constitutes an introduction to creep and to the creep response of Aluminium and its alloys. Its major goals are: to provide basic information on creep and its mechanisms to give a description of the more extensively used mathematical relations among creep variables (time, stress and temperature) to illustrate the creep response of pure Aluminium and of Al-Mg alloys to provide a syn...

Local strength of friction stir (FS) welds and FS processed aluminium alloys in heat treatable aluminium alloys is dominated by precipitation hardening. Strengthening due to stored dislocations is generally limited to 40MPa, and grain size strengthening is generally less than 10MPa. Local crystallographic texture can cause yield strength variation on the order of 5%. Published models for streng...

This review attempts to present the current understanding of the mechanism of pitting corrosion of heat treatable aluminium alloys and their welds. The role of alloying elements and intermetallic phases on the corrosion behavior of these alloys has been discussed. Pitting mechanism of aluminiumcopper alloys is specifically discussed. Finally effect of welding on the pitting corrosion of these a...

The relation between chemical composition, microstructure and oxidation properties has been investigated on various FeAl based alloys, the aim being to induce changes in the microstructure of the compound by selective oxidation of aluminium. Oxidation kinetics that was evaluated on bulk specimens showed that, due to fast diffusion in the alloys, no composition gradient is formed during the alum...

This paper present a mechanical characteristics on fatigue crack propagation in Aluminium Plate based on strain and stress distribution using the abaqus software. The changes in shear strain and stress distribution during the fatigue cycle with crack growth is identified. In progressive crack in the strain distribution and the stress is increase in the critical zone. Numerical Modal analysis of...

Aluminium-silicon alloys have gained increasing market share in the automotive and aerospace industry because of increased environmental demands. These alloys have a high strength-to-weight ratio, good corrosion resistance, castability and recycling potential. However, variations in properties and limited performance at elevated temperature are restricting these alloys from use at elevated temp...

Shape-memory alloys are known to have two unique characteristics: a shape-memory effect and superelasticity. The shape-memory effect is the ability of the alloys to revert to their initial shape upon being heated until they enter their phase transformation temperature. Superelasticity is where the alloys exhibit comparatively large recoverable strain. Different families of shape-memory alloys h...

This lecture aims at providing a survey of the metallographic techniques available for the examination of aluminium and its alloys. The information must be sufficient to be sure that the students and the users are able to choose the most suitable technique to solve their problems in the examination of samples. The lecture should contain a direct understanding of the main problems in the metallo...

A discontinuously reinforced MMC containing 12 vol % Sic particles in an Al-Cu-Mg alloy (AA 2124) matrix has been diffusion bonded. Thick interlayers of different superplastic aluminium alloys (Al-Li 8090 and A1-Cu SUPRAL) were used to reduce the bonding pressure and ensure complete surface contact. Microstructural studies shown higher continuity in joints bonded with 8090 interlayer than with ...

L. Kuchariková, E. Tillová, J. Belan, M. Chalupová, A. Vaško, I. Švecová, University of Žilina, Faculty of Mechanical Engineering, Slovakia The present work deals with evaluation of eutectic Si (its shape, size, and distribution), dendrite cell size and dendrite arm spacing in aluminium cast alloys which were cast into different moulds (sand and metallic). Structural parameters were evaluated u...