نتایج جستجو برای: anodic polarization
تعداد نتایج: 71891 فیلتر نتایج به سال:
A series ef binary Ti-Cu alloys containing 5-20 mass% Cu was prepared, and the corresien behavior of a-Ti and Ti2Cu composing the Ti-Cu alloys were examined based on the anodic polarization curves and released iens in O.9% NaCl and 1% lactic acid solutions. In both selutions, the Ti-Cu alloys showed the same anodic polarization curves as titanium in the conditien below 1.4 V. Hewever, precipita...
The electrochemical behavior of copper in 0.05 M HCl and 0.05 M NaCl carried out at open-circuit potential and at constant anodic potential after one hour has been investigated using electrochemical impedance spectroscopy (EIS) at 20 °C, 40 °C and 60 °C. The formation of copper chloride (CuCl) film does not protect copper from dissolution in the chloride media. The physical properties of the pa...
The increase in the rate of hydrogen evolution (HE) on dissolving Mg surfaces with increasing anodic current density or potential, which is sometimes called the negative difference effect, has been the topic of much discussion in recent years. A review of the very recent contributions to this subject is given in this paper. Increased catalytic activity of the corrosion product layer, either fro...
Corrosion fatigue (CF) tests were carried out on bulk glassy Zr52.5Cu17.9Al10Ni14.6Ti5 (Vitreloy 105) samples under load-controlled three-point bending conditions with a load ratio of R = 0.1 in 0.01 M Na2SO4 + 0.01 M NaCl electrolyte. During cyclic testing, the bar-shaped specimens were polarized in situ at constant potentials and the current was monitored. Three different anodic potentials wi...
The polarization behaviour of (Biz03)0.,5(Er,0,),,25(BE25) with a co-pressed gold gauze electrode was studied as a function of temperature and oxygen partial pressure in a three electrode cell. The anodic polarization is smaller than the cathodic polarization. The cathodic charge transfer coefficient, (Y,, is about 0.5 while the anodic one, (Y., is about 1.5. The exchange current density shows ...
In this research pitting Corrosion of a sensitized 316 stainless steel was investigated employing potentiodynamic, potentiostatic techniques. Sensitization process was carried out on as-received alloy by submitting the specimen in electric furnace set at 650°Cfor five hours and then the specimen was quenched 25°C water. Potentiodynamic polarization of as received and sensitized specimens in 1M ...
The electrochemical behavior of 6063 aluminum alloy in ethylene glycol-water mixture was investigated by polarization curves and AC impedance measurements (EIS). The results obtained from polarization curves showed that corrosion rate decreased with increasing ethylene glycol concentration. EIS data showed the decrease in the interface capacitance which caused by adsorption of ethylene glycol ...
Piperazine and its derivatives such as phosphates, carbonates, benzoates, cinnamate and maleate were developed and investigated as vapor phase corrosion inhibitors by weight loss, potentiodynamic polarization methods for mild steel. All of these compounds have shown good inhibition efficiency for mild steel after 30 days under continuous condensation test (CT). The potentiodynamic polarization ...
y-tial intermetallic alloy have a good potential for use as biomaterial, due to its good corrosion resistance. in this paper, two fundamental electrochemical techniques namely electrochemical impedance spectroscopy and potentiodynamic anodic polarization were used to evaluate the corrosion performance of g-tial in ringer's solution. surface modification treatments were employed with the pu...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید