Titanium (Ti) is one of the most promising biomaterial for biomedical devices due to its high corrosion resistance and specific combination of strength and biocompatibility. Titanium dioxide (TiO2) nanostructures are obtained by electrochemical anodization of Ti foils under self-organization condition; anodization parameters such as anodization time, voltage, temperature and most important elec...

A detailed study of the pore-widening rate of nanoporous anodic alumina layers as a function of the anodization voltage was carried out. The study focuses on samples produced under the same electrolyte and concentration but different anodization voltages within the self-ordering regime. By means of ellipsometry-based optical characterization, it is shown that in the pore-widening process, the p...

Wet-chemical etching of the barrier oxide layer of anodic aluminum oxide (AAO) was systematically investigated by using scanning electron microscopy (SEM), secondary ion mass spectrometry (SIMS), and a newly devised experimental setup that allows accurate in situ determination of the pore opening point during chemical etching of the barrier oxide layer. We found that opening of the barrier oxid...

Anodization techniques by alternating current (ac) are introduced in this review. By using ac anodization, laminated alumina films are fabricated. Different types of alumina films consisting of 50-200 nm layers were obtained by varying both the ac power supply and the electrolyte. The total film thickness increased with an increase in the total charge transferred. The thickness of the individua...

Citation: Salerno M, Stępniowski WJ, Cieślak G, Norek M, MichalskaDomańska M, Karczewski K, Chilimoniuk P, Polkowski W, Jóźwik P and Bojar Z (2016) Advanced Image Analysis of the Surface Pattern Emerging in Ni3Al Intermetallic Alloys on Anodization. Front. Mater. 3:34. doi: 10.3389/fmats.2016.00034 advanced image analysis of the surface Pattern emerging in ni3al intermetallic alloys on anodization

Anodic porous alumina is a known material based on an old industry, yet with emerging applications in nanoscience and nanotechnology. This is promising, but the nanostructured alumina should be fabricated from inexpensive raw material. We fabricated porous alumina from commercial aluminum food plate in 0.4 M aqueous phosphoric acid, aiming to design an effective manufacturing protocol for the m...

Modifying the diameter of the pores in nanoporous anodic alumina opens new possibilities in the application of this material. In this work, we review the different nanoengineering methods by classifying them into two kinds: in situ and ex situ. Ex situ methods imply the interruption of the anodization process and the addition of intermediate steps, while in situ methods aim at realizing the in-...

The self-ordering of nanoporous anodic aluminum oxide (AAO) in the course of the hard anodization (HA) of aluminum in sulfuric acid (H2SO4) solutions at anodization voltages ranging from 27 to 80 V was investigated. Direct H2SO4-HA yielded AAOs with hexagonal pore arrays having interpore distances D(int) ranging from 72 to 145 nm. However, the AAOs were mechanically unstable and cracks formed a...

We have successfully prepared anodized alumina membrane distributed Bragg reflector (DBR) using electrochemical anodization method. The transmission peak of this distributed Bragg reflector could be easily and effectively modulated to cover almost any wavelength range of the whole visible spectrum by adjusting anodization temperature.

in this research work nano porous silicon layers with different porosity were prepared by using electrochemical etching. surface morphology and size of pores were investigated by scanning electron microscopy (sem).tio2 thin films with ebpvd method have been deposited on the surface of psi layers. the influence of anodization conditions such as anodization time interval and current density on el...