The prediction capability of the brake system vibration is still unable to cover a broad range of frequencies. Current predictive models are contained within a particular range to cater for specific vibration types. Therefore, a numerical model which could make predictions in a broad spectrum range is required. The model presented in this paper is derived with such aim. The model is derived fro...

Geometric imperfections on brake rotor surface are well-known for causing periodic variations in brake torque during braking. This leads to brake judder, where vibrations are felt in the brake pedal, vehicle floor and/or steering wheel. Existing solutions to address judder often involve multiple phases of component design, extensive testing and improvement of manufacturing procedures, leading t...

We have previously demonstrated an abnormally delayed mean brake response time and an increased frequency of abnormally delayed brake responses in a group of neuropathic drivers with diabetes compared with a control group of drivers with neither diabetes nor lower extremity neuropathy. The objective of the present case-control study was to compare the mean brake response time between 2 groups o...

This paper proposes an approach to investigate the influencing factors of the brake pad on the disc brake squeal by integrating finite element simulations with statistical regression techniques. Complex eigenvalue analysis (CEA) has been widely used to predict unstable frequencies in brake systems models. The finite element model is correlated with experimental modal test. The ‘input-output’ re...

Present cable trolley brakes used in material transfer or overhead trolley transport systems uses twin shoe caliper brakes operated by solenoid. These brakes are not fail safe, means that slip occurs between cable and brake caliper. Sometimes overloading leads to wear of brake shoe material. The failure of brake system may increase the chances to loss of life of occupant. These conventional cal...

For the safety problem of heavy duty vehicles running on long downhill sections, a model was built for the application of engine brake and service brake combination based on test results. And a model of brake temperature rise for heavy duty vehicles running on long downhill sections was also established. For different braking modes, gear positions, speed and downhill slopes, brake temperature r...

A unique decoupling feature in frictional disk brake mechanisms, derived through kinematic analysis, enables modularised design of an Anti-lock Braking System (ABS) into a sliding mode system that specifies reference brake torque and a tracking brake actuator controller. Modelling of brake actuation, vehicle dynamics, and control design are described for a scaled vehicle system. The overall con...

In this paper, we first establish the Bott-type iteration formulas and some abstract precise iteration formulas of the Maslov-type index theory associated with a Lagrangian subspace for symplectic paths. As an application, we prove that there exist at least [ n 2 ] + 1 geometrically distinct brake orbits on every C compact convex symmetric hypersurface Σ in R satisfying the reversible condition...

We developed a passive haptic technique, using the brake of a DC motor, to create a greater perception of impulse force. We found that when using the brake of a DC motor, delivering two short pulses immediately prior to the main brake significantly increases the operator’s perception of impulse force. This finding was verified during our empirical assessment. In the experiment, all five partici...