The present study aimed to investigate the role of magnitude in adaptive response of osteoblasts exposed to compressive stress. Murine primary osteoblasts and MC3T3-E1 cells were exposed to compressive stress (0, 1, 2, 3, 4, and 5 g/cm2) in 3D culture. Cell viability was evaluated, and expression levels of Runx2, Alp, Ocn, Rankl, and Opg were examined. ALP activity in osteoblasts and TRAP activ...

This work introduces Mg-4Zn-3Gd-1Ca/2ZnO (wt.%) nanocomposite fabricated using the technique of disintegrated melt deposition and extrusion. Addition of ZnO nanoparticles enhanced the compressive strengths of alloy by ~100 MPa. Nanocomposite samples display high strength and good ductility: 0.2% compressive yield stress of 355 MPa, ultimate compressive stress of 703 MPa, and compressive failure...

The research reported herein studied the permeability of concrete containing recycled-concrete aggregate (RA), superfine phosphorous slag (PHS), and ground granulated blast-furnace slag (GGBS) with and without stress. Test results showed that the chloride diffusion coefficient of RA concrete (RAC) without external loads decreased with time, and the permeability of RAC is much lower than that of...

BACKGROUND CONTEXT The intervertebral disc is a common source of low back pain (LBP). Prospective studies suggest that treatments that intermittently distract the disc might be beneficial for chronic LBP. Although the potential exists for distraction therapies to affect the disc biomechanically, their effect on intradiscal stress is debated. PURPOSE To determine if distraction alone, distract...

The compressive mechanical properties of uniform and density-graded Al-6061 foams, produced by replication of polymer foams, are measured. hile the uniform foam shows compressive behavior characteristic of conventional (uniform) metallic foams with a near constant plateau stress, he density-graded foam exhibits a smoothly rising plateau stress. This behavior is modeled using a simple series com...

Deep-sea permanent magnet motor equipped with fluid compensated pressure-tolerant system is compressed by the high pressure fluid both outside and inside. The induced stress distribution in stator core is significantly different from that in land type motor. Its effect on the magnetic properties of stator core is important for deep-sea motor designers but seldom reported. In this paper, the str...

This paper demonstrates a new power cycle for direct conversion of mechanical energy into electrical energy under a thermal bias. The cycle consisted sequentially of (i) an electric poling process under zero stress, (ii) an isoelectric process consisting of applying a uniaxial compressive stress rH followed by (iii) an electric de-poling process under constant compressive stress, and finally (i...

Thin compressive layers within a laminar ceramic arrest large cracks (surface and internal) and produce a threshold strength. This phenomenon increases the damage tolerance of ceramics and will allow engineers to design reliable ceramic components for structural applications. The stress intensity factor derived for a crack sandwiched between two compressive layers suggests that the threshold st...

Ultrasonic peening treatment (UPT) as a method of severe plastic deformation was used to treat cruciform welded joints of Q345 steel. The application of UPT achieves material surface nanocrystallization of the peening zone, reduces stress concentration, and produces residual compressive stresses at the welded toe. Micro-structure, hardness, stress relief, S-N curve, and the fatigue fracture mec...

loading conditions and complex geometry have led the cylinder heads to become the most challenging parts of diesel engines. one of the most important durability problems in diesel engines is due to the cracks valves bridge area. the purpose of this study is a thermo-mechanical analysis of cylinder heads of diesel engines using a two-layer viscoplasticity model. in this article, mechanical prope...