The heat pipe applications have been coupled with the renewable energy such as solar energy, waste heat and geothermal energy. Thermosyphon Rankine Cycle (TRC) is a vertical wickless heat pipe engine. In this engine, the turbine is installed between the insulated section and a condenser section of thermosyphon. The mechanical energy developed by the turbine can be converted to electricity, by d...

An investigation of heat recovery for power generation using an absorption-Rankine cycle with a low temperature waste heat source was conducted. In such a cycle, the condenser and boiler of a conventional Rankine system are replaced with an absorber and desorber. A recuperative solution heat exchanger is also incorporated between the absorber and desorber to minimize the external heat input. An...

In order to dissipate the heat generated by electronic boxes in avionic systems, a copperwater LHP with a flat-oval evaporator was fabricated and tested at steady-state. The LHP consists of a flat shaped evaporator, 7 mm thick, including compensation chamber with attached heat exchanger. The condenser is cooled by forced convection of liquid. The variable parameters are the heat sink and ambien...

The Organic Rankine Cycle (ORC) has been proved a promising technique to exploit waste heat from Internal Combustion Engines (ICEs). Waste heat recovery systems have usually been designed based on engine rated working conditions, while engines often operate under part load conditions. Hence, it is quite important to analyze the off-design performance of ORC systems under different engine loads....

This paper presents experimental results from a prototype of a microchannel heat exchanger used in a residential air-conditioning system as an air-cooled condenser. The main objectives were to analyze effects of the microchannel condenser on system performance. The commercially available system that utilizes a condenser with a round tube and plate fins was experimentally evaluated first, then t...

Condenser is a device in which heat is transferred from one medium to another across a solid surface. The performance of condenser deteriorates with time due to fouling on the heat transfer surface. It is necessary to assess periodically the condenser performance, in order to maintain at high efficiency level. Industries follow adopted practices to monitor but it is limited to some degree. In t...

Water-cooled chiller systems have typically been designed around entering condenser water temperatures of 85°F with a Optimization of Water Cooled Chiller – Cooling Tower Combinations The warm water leaving the chilled water coils is pumped to the evaporator of the chiller, where the unwanted heat from the building is transferred by the latent heat of vaporization of the refrigerant. The compre...

Today, rapid developments are experienced in terms of energy consumption and efficiency air conditioning systems. Among these systems, waste heat renewable sources used absorption cooling Although the initial investment cost this system is high, operating low due to use heat. In study, effect generator, condenser, absorber evaporator temperatures on performance (COP) systems with single-stage L...

In general, plastics have low density, are insulating to electricity, varying mechanical strength, limited temperature resistance, and chemical resistance so that they widely used because of their advantages. Efforts manage plastic waste practically effectively reduce the widespread pollution. The purpose this study was find out effect use condenser cooling water on results distillation capacit...