Introduction: Dental ceramics are considered as materials that can restore the appearance of natural teeth. Etching the inner surface of a ceramic restoration with hydrofluoric acid (HF) followed by using a silane coupling agent is a well-known and recommended method to increase the bond strength. The aim of etching on ceramic structure is to enhance the surface roughness (Ra) and energy and to...

background: repair bond strength of different composite resins has been assessed in few studies. in addition, reports on the effi cacy of surface treatments are debated. therefore, this in vitro study was conducted to evaluate the effect of three surface treatments on two nanocomposites versus a microhybrid composite. materials and methods: in this experimental study, 135 composite blocks (45 s...

Aim: To assess the influence of dental etching on the shear strength of different glass ionomer cements. Methods: The crown of 60 bovine incisors was prepared to obtain a flat, smooth surface, were attached to a PVC tube and randomly divided into six groups: Group 1 – Riva Self Cure without etching; Group II – Riva Self Cure with pre-etching; Group III – Maxxion R without etching; Group IV – Ma...

Objectives: Bonding of zirconia crowns and bridges to abutments is important, not only bonding of the thin resin layer to the abutment, but also bonding to the zirconia ceramic is crucial. Both mechanical and chemical adhesion are desired. Mechanical retention of dental porcelain achieved by etching with moderately concentrated hydrofluoric acid is not possible with zirconia ceramics. The purpo...

Length of resin tags yielded by utilization of an one-step conventional adhesive system and self-etching adhesive system on unground enamel was observed. In study Groups I and III, the enamel surface was etched for 60 seconds with 35% phosphoric acid gel and adhesive systems PQ1 (Ultradent Products, Inc) and Adper Prompt L Pop (3M/ESPE) were applied. Adper Prompt L Pop (3M/ESPE) was also applie...

the major foible of dental ceramics is their brittle nature. therefore, the producers of these materials have focused on the “strength” issue. a method of increasing strength is ion exchange on porcelain surface which leads to formation of a compressive crust that opposing forces should overcome before developing a crack. in current study, ion exchange in two types of porcelain, ceramco ii whic...

The surface morphology and crystal structure change of dental zirconia after hydrofluoric acid (HF) etching were evaluated. Four groups of sintered zirconia specimens were 1) control group, 2) immersion in 9.5%HF at 25°C for 1, 2, 3, or 24 h, 3) immersion in 9.5%HF at 80°C for 1, 3, 5, or 30 min and 4) immersion in 48%HF at 25°C for 30 or 60 min. The specimens were evaluated under SEM and XRD. ...

AIMS These were to firstly evaluate the shear bond strength of a composite resin to primary dental enamel treated with a standard adhesive system but with varying phosphoric acid etching times along with a self-etching prime, secondly to analyse the etching patterns using SEM. METHODS Forty primary molars were used. In the first three groups, following acid etching, a layer of Prime & Bond NT...