This paper presents an exact analytical solution for two-dimensional conductive heat transfer in spherical composite pressure vessels .The vessels are in spherical shape and fibers are winded in circumferential direction. The analytical solution is obtained under the general boundary conditions which consist of convection, conduction and radiation inside/outside of vessel. The heat transfer equ...

this paper presents a numerical simulation of developing flow and heat transfer of a viscoelastic fluid in a rectangular duct. in fully developed flow of a viscoelastic fluid in a non-circular duct, secondary flows normal to the flow direction are expected to enhance the rate of heat and mass transfer. on the other hand, properties such as viscosity, thermal conductivity, specific heat and rela...

In this article, stream flow effectivness is based on hydraulic network studied in the shell-side of a shell and tube heat exchange as a case study. For an appropriate heat exchangers rating design to meet a specified duty, it's better to consider each stream flow separately. Using the hydraulic network principals, a set of the correlations for calculating different stream flow rates in the cro...

The present paper deals with the prediction of three-dimensional fluid flow and heat transfer in rib-roughened ducts of square cross-section. Such flows are of direct relevance to the internal cooling system of modern gas turbine blades. The main objective is to assess how a recently developed variant of a cubic non-linear model (proposed by Craft et al. (1999)), that has been shown to produce ...

In internal combustion engines, exhaust valve and its seat gain considerable temperature as the hot gases exit through them. So, the rate of heat transfer should be under control. In this study, the contact heat transfer coefficient has been estimated. An experimental study on an Air-Cooled internal combustion engine cylinder head has been considered. Using the measured temperatures of sensors ...

metric (mapping evapotranspiration at high resolution with internalized calibration) is known as an appropriate surface energy balance model for the estimation of the spatial distribution of evapotranspiration (et) in semi-arid regions. based on lysimeter measurements, metric has shown et estimates of 10% on a sub-field scale on a daily basis. there is a need to identify how the model is sensit...

An analytical study was performed to study effects of thermo-diffusion and chemical reactions on a three-dimensional MHD mixed convective flow of dissipative fluid along an infinite vertical porous plate with transverse sinusoidal suction velocity. The parabolic partial differential equations governing the fluid flow, heat transfer, and mass transfer were solved using perturbation technique and...

There are a number of systems in which supercritical cryogenic fluids are used as coolants or propellant fluids. In some modern military aircraft, the fuel is pressurized above its critical point and used as a coolant to remove heat from the aircraft engine. Accurate prediction of heat transfer coefficients to turbulent flows of supercritical fluids is essential in design of such systems. One o...

A quad inserted into a turbulent boundary layer of a flat plate and its effect on average heat transfer and the friction coefficient is studied. To optimize this effect, the edge sizes and distance of the quad from the flat plate are continually modified. In each case, simultaneously the heat transfer enhancement and reduction in skin friction are analyzed. For optimization, the genetic algorit...