Various heat treatments are applied to improve the mechanical properties of steels depending on intended use. In this study, variation fatigue strength H13 hot work tool steel with treatment in a GS 550 bath was investigated. It investigated by applying four different as first preheating, second hardening and hardening. Each batch samples subjected rotating bending test at room temperature afte...

Metallic nanowires usually exhibit ultrahigh strength but low tensile ductility owing to their limited strain hardening capability. Here we study the unique strain hardening behavior of the five-fold twinned Ag nanowires by nanomechanical testing and atomistic modeling. In situ tensile tests within a scanning electron microscope revealed strong strain hardening behavior of the five-fold twinned...

The SiC particles (SiCp, mass fraction 30 %) reinforced with the Al-Si-Cu-Mg matrix composite have been prepared using one-way press method, sintering, and hot extrusion. The composite was subjected to solid solution treatment at temperatures of 470 °C, 485 °C, 500 °C, 515 °C, and 530 °C for 4 h. The sample was then subjected to ageing treatment at temperatures of 160 °C and 180 °C during diffe...

Generally a simple power law ~ = K E" (where K and n are empirical constants called the strength coefficient and the work hardening coefficient respectively) is used to describe plastic stress-strain dependence of deformable metals (1,2). This equation was employed by Low (3) to describe the uniaxial tensile behavior of an annealed 70/30 brass. The slope of the corresponding double logarithmic ...

1967 Price 8s 6d net .-summary The time hardening, life fraction and strain hardening hypotheses variously proposed to describe tiniaxisl creep deformation are considered and compared with experimental evidence. It is concluded that the strain hardening hypothesis is the most nearly correct, the experimental strains usually being within 50% of those predicted. Further, rheological and modified ...

The change in near-tip stress field in Small Scale Yielding (SSY) for cracks located at an interface between two materials with different plastic work hardening is investigated. The difference in hardening is termed hardening mismatch, and is quantified through the parameter n, which is the difference in hardening exponent between the two materials. For cracks in elastic-ideally plastic materia...

Drought stress is the main cause of mortality of holm oak (Quercus ilex L.) seedlings in forest plantations. We therefore assessed if drought hardening, applied in the nursery at the end of the growing season, enhanced the drought tolerance and transplanting performance of holm oak seedlings. Seedlings were subjected to three drought hardening intensities (low, moderate and severe) for 2.5 and ...

Strain hardening capability is critical for metallic materials to achieve high ductility during plastic deformation. A majority of nanocrystalline metals, however, have inherently low work hardening capability with few exceptions. Interpretations on work hardening mechanisms in nanocrystalline metals are still controversial due to the lack of in situ experimental evidence. Here we report, by us...

The microstructural evolution during low temperature ageing of two commercial purity alloys (Al1.2Cu-1.2Mg-0.2Mn and Al-1.9Cu-1.6Mg-0.2Mn at.%) was investigated. The initial stage of hardening in these alloys is very rapid, with the alloys nearly doubling in hardness during 20 h ageing at room temperature. The microstructural evolution during this stage of hardening was investigated using diffe...

Based on experimental results, a dislocation material model describing the dynamic strain aging effect at different temperatures is presented. One and two stage loading tests were performed in order to investigate the influence of the loading direction as well as the temperature influence due to the hardening mechanism. Bergström’s theory of work hardening was used as a basis for the model deve...