In this study, synthetic sulfonated polymers were used in order to enhance the rheological properties of drilling fluids. The capability of these polymers in reducing the effects of environmentally friendly, but harmful, pollutants such as cement, calcium chloride, gypsum as well as pH changes were investigated. In the present work, two sulfonated synthetic polymers, namely Polythin and Polydri...

Solids control equipment at the rig site is used to remove rock cuttings or low-gravity solids (LGS) from drilling fluids to allow the fluid to return to the active system in a re-usable condition. Typical equipment, such as shakers and centrifuges, remove LGS particles greater than 5-7 microns. Build up of finer solids in the fluid can create problems for efficient drilling such as drillpipe s...

A gas kick simulation model for deep-water horizontal well with diesel-based drilling fluid is presented in this paper. This model is mainly based on the mass, momentum, and energy conservation equations. The unique aspect of this model is the fluid-gas coupling and the change of mud properties after the gas influx from the formation. The simulation results show that the gas in an annulus disso...

Currently, the drilling fluid processing and recycling has gained more attention from various oilfields. Whether the waste drilling fluid’s processing and recycling is good or not will directly affect the development of oil industry. Therefore, the urgent affair is to develop and research the processing method of waste drilling fluid.This article describes various processing methods of waste dr...

Maybe viscosity in drilling fluid is the most important parameter because cutting removal from well are task of viscose fluid. If viscosity of fluid is less than particular value, cutting will settle down in well and drilling operation will be stopped. In this study, synthesis of Alumina/Polyacrylamide nanocomposite through solution polymerization method was performed. Rheological behavior of m...

Maybe viscosity in drilling fluid is the most important parameter because cutting removal from well are task of viscose fluid. If viscosity of fluid is less than particular value, cutting will settle down in well and drilling operation will be stopped. In this study, synthesis of Alumina/Polyacrylamide nanocomposite through solution polymerization method was performed. Rheological behavior of m...

Designing drilling fluids for drilling in deep gas reservoirs and geothermal wells is a major challenge. Cooling drilling fluids and preparing stable mud with high thermal conductivity are of great concern. Drilling nanofluids, i.e. a low fraction of carbon nanotube (CNT) well dispersed in mud, may enhance the mixture thermal conductivity compared to the base fluids. Thus, they are potentially ...

Formate drilling and completion fluid system is a new type of clean organic salt brine system which has been developed from inorganic salt brine drilling fluid system. It is beneficial to protecte and find hydrocarbon reservoir. Due to the solid free system, the damage of solid phase particles on reservoir, especially low permeability oil and gas layer, can be greatly eliminated, at the same ti...

Oil and gas drilling operations use drilling fluids (mud) to lubricate the drill bit and stem, transport formation cuttings to the surface, and seal off porous geologic formations. Following completion of the well, waste drilling fluid is often applied to cropland. We studied potential changes in soil compaction as indicated by cone penetration resistance, pH, electrical conductivity (EC(e)), s...

This study deals with onshore oilfield drilling fluid system to drill corrosion. Corrosion under static and dynamic conditions of the drilling fluid was evaluated. The effect of temperature and pressure on corrosion was examined. Corrosion was more severely affected by temperature compared to pressure. The combined effect of a deoxidizing agent and an inhibitor was observed to exhibit better pr...