In this work dynamic recrystallization behavior of AISI 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 C -1200 C and strain rate range of 0.001 s-1 - 1 s-1. The obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. The flow stress and strain corresponding to the critical, pe...

strain induced precipitation in hsla-100 steel was investigated by conducting hotcompression and relaxation tests at temperature range of 850°c to 1100°c and strain rate of 0.001s-1 to 1s-1. the absence of dynamic recrystallization at temperatures below 1000°c was attributedto the influence of dynamic precipitation. the stress relaxation tests showed that strain inducedprecipitation is possible...

A crack-free Ti-43Al-9V-0.2Y alloy sheet was successfully fabricated via hot-pack rolling at 1200 °C. After hot-rolling, the β/γ lamellar microstructure of the as-forged TiAl alloy was completely converted into a homogeneous duplex microstructure with an average γ grain size of 10.5 μm. The dynamic recrystallization (DRX) of the γ phase was systematically investigated. A recrystallization fract...

the effects of carbon content on the dynamic and static softening mechanisms of ti microalloy steels were investigated both in ferrite and austenite regions. the results obtained showed that recrystallization rate decreased as the percentage of carbon content was increased from 0.0035 to 0.110. this is due to the ti(cn) and tic precipitates and also the free carbon content. in the ferrite regio...

The hot deformation behavior and microstructural evolution of an Al-Zn-Mg-Cu (7150) alloy was studied during hot compression at various temperatures (300 to 450 °C) and strain rates (0.001 to 10 s-1). A decline ratio map of flow stresses was proposed and divided into five deformation domains, in which the flow stress behavior was correlated with different microstructures and dynamic softening m...

A physically-based two-site mean field model has been developed to describe the microstructural evolution due to recrystallization during and after deformation. The model has been applied to predict the recrystallized fraction, recrystallized grain size, and flow stress of 304L austenitic stainless steel during discontinuous dynamic recrystallization (DDRX), post-dynamic recrystallization (PDRX...

the flow stress of steel depends significantly on microstructural changes taken place during hot deformation processes. in hot deformation processes, the flow stress of steel is influenced by two main metallurgical phenomena, i.e. recovery and recrystallization, along with its chemical composition and thermo-mechanical parameters. the final mechanical properties of steel are also determined by ...

Strain induced precipitation in HSLA-100 steel was investigated by conducting hotcompression and relaxation tests at temperature range of 850°C to 1100°C and strain rate of 0.001s-1 to 1s-1. The absence of dynamic recrystallization at temperatures below 1000°C was attributedto the influence of dynamic precipitation. The stress relaxation tests showed that strain inducedprecipitation is possible...

The effects of carbon content on the dynamic and static softening mechanisms of Ti microalloy steels were investigated both in ferrite and austenite regions. &#10The results obtained showed that recrystallization rate decreased as the percentage of carbon content was increased from 0.0035 to 0.110. This is due to the Ti(CN) and TiC precipitates and also the free carbon content. In the ferrite r...

This paper investigates the microstructural evolution and grain refinement kinetics of a solution-treated Cu-0.1Cr-0.06Zr alloy during equal channel angular pressing (ECAP) at a temperature of 673 K via route BC. The microstructural change during plastic deformation was accompanied by the formation of the microband and an increase in the misorientations of strain-induced subboundaries. We argue...