We demonstrate a method to manage the locked multichannel output from a mode-locked Cr:forsterite laser cavity, which was achieved by inserting a Fabry–Perot etalon into the oscillator. It is found that the thickness of the etalon determines the channel spacing and its surface reflectivity affects channel linewidth and channel pulsewidth. Following Fabry–Perot theory, we can use these facts to ...

We present a tunable single-frequency CW Ti:sapphire laser with intensity noise manipulation. The manipulation of the laser intensity noise is realized by varying the frequency of the modulation signal loaded on the electrodes of an intracavity electro-optic etalon. A lithium niobate (LiNbO3) crystal is used to act as the electro-optic etalon, and its electro-optic effect is utilized...

Compact spectrometers are crucial in areas where size and weight may need to be minimized. These types of spectrometers often contain no moving parts, which makes for an instrument that can be highly durable. With the recent proliferation in low-cost and high-resolution cameras, camera-based spectrometry methods have the potential to make portable spectrometers small, ubiquitous, and cheap. Her...

The use and analysis of solid Fabry-Perot etalons for interferometry and laser control are discussed and supported with experimental data. Low angle scattering is found to be an important factor influencing finesse and peak transmission. Thermal tuning sensitivity and wedge-angle control with thermal gradients are analyzed and illustrated. Control of laser oscillations using a solid-state etalo...

Abstract Investigations on 405 nm diode-pumped cw ruby lasers operated in less than 3 mm plane-parallel resonators are reported. With 2.5 long crystals TEM 00 emission with output powers up to 40 mW achieved. an uncoated thin etalon of 0.13 thickness, single frequency both lines R1 and R2 is possible. the piezoelectric shifting one resonator mirror corresponding tilting etalon, tuning 400 GHz h...

A coherent multiple imaging technique for use in optical microlithography was studied. The technique involves placing a thin Fabry-Perot etalon between the mask and the projection lens of an optical stepper. An optical lithographic computer simulation tool, Prolith/2, was used to evaluate the aerial image profile obtained for extended mask structures such as typical contact hole arrays and line...

We have constructed a new facility at the National Institute of Standards and Technology (NIST) to measure the index of refraction of transmissive materials in the wavelength range from the visible to the vacuum ultraviolet. An etalon of the material is illuminated with synchrotron radiation, and the interference fringes in the transmittance spectrum are measured using a Fourier transform spect...

Compact spectrometers fabricated by placing a wedged etalon or a linear variable filter in front of a linear photodiode array typically do not exhibit the spectral resolution of a parallel filter of the same finesse. A theoretical analysis of the beam emerging from a wedged etalon is shown to predict a comalike aberration, explaining the loss in resolution. This analysis also predicts a focused...