Gear plunge shaving is one of the most efficient ways to finish gears. It has been a challenge for a long time to design and manufacture a plunge shaving cutter to induce gear tooth modification. This paper proposes a method for designing plunge shaving cutters to manufacture gears with modifications analytically. By integrating B-spline interpolation, differential geometry, and design optimiza...

A decoupled fuzzy sliding-mode control for an aeroelastic system is derived. This aeroelastic dynamic system describes the nonlinear plunge and pitch motions of a wing section, using a single trailing-edge flap as the control input. The decoupled fuzzy sliding-mode control design method is proposed to simultaneously control both the plunge and pitch motions of the aeroelastic system. In this de...

Modern aeroengine designs strive for peak specific fuel and thermal efficiency. To achieve these goals, engines have more highly loaded compressor stages, thinner aerofoils, blended titanium integrated disks (blisks) to reduce weight. These configurations promote the occurrence of aeroelastic phenomena such as flutter. Two important parameters known influence flutter stability are reduced frequ...

In this paper a new method for determining the search area for motion estimation algorithm based on block matching is suggested. In the proposed method the search area is adaptively found for each block of a frame. This search area is similar to that of the full search (FS) algorithm but smaller for most blocks of a frame. Therefore, the proposed algorithm is analogous to FS in terms of reg...

Based on 1143 focal mechanisms in Tienshan area from 1900 to 2019, according the world stress map classification criterion, main types of dislocations are thrust and strike slip; The results parameter statistics show that nodal plane mechanism solution is basically consistent with tectonic area, orientation P axis perpendicular which shows horizontal nearly NS thrust. direction maximum principa...

in this paper a novel hybrid algorithm for harmonics estimation in power systems is proposed. the estimation of the harmonic components is a nonlinear problem due to the nonlinearity of phase of sinusoids in distorted waveforms. most researchers implemented nonlinear methods to extract the harmonic parameters. however, nonlinear methods for amplitude estimation increase time of convergence. hen...