A concise one dimensional thermal-hydraulic two-fluid model is presented for the numerical prediction of sulphur dioxide absorption from the flue gas onto drops of the water-limestone slurry in the vertical spray tower absorber. The model is based on mass, momentum and energy balance equations for each phase separately, i.e. downward falling droplets of water-limestone slurry and upward flowing...

Oxy-fuel coal combustion with flue gas re-circulation is known to be one of the most promising methods for reducing CO2 emissions from coal combustion power plants. In the oxy-fuel system, the combustion atmosphere consists of only O2 separated from air and flue gas re-circulated from a stack. Therefore, the flue gas is dominated by CO2 without any nitrogen gas. The most attractive potential as...

In this paper, an improved system to efficiently utilize the low-temperature waste heat from the flue gas of coal-fired power plants is proposed based on heat cascade theory. The essence of the proposed system is that the waste heat of exhausted flue gas is not only used to preheat air for assisting coal combustion as usual but also to heat up feedwater and for low-pressure steam extraction. Ai...

The simultaneous removal of SO2/NO2 by limestone slurry was studied in a gas-liquid bubbling reactor. Experiments were carried out to find the effect of various operating parameters such as inlet concentration of SO2 and NO2, reaction temperature, O2 content in the flue gas and additive on the SO2 and NO2 removal efficiencies. SO2 removal efficiency decreased with inlet NO2 concentration, react...

Efficiency of Flue Gas Desulfurization System (FGD) is affected by numerous technical parameters like: proper fuel preparation, quantity and quality of fuel, combustion conditions in furnace chamber, quality of flue gas corresponding to the operating conditions of FGD system, design quantity and quality of flue gas at the inlet of FGD system, design quantity and quality of used sorbent, design ...

Combustion of the municipal waste generates highly corrosive gases (HCl, SO2, NaCl, KCl and heavy metals chlorides) and ashes containing alkaline chlorides and sulphates. Currently, corrosion phenomena are particularly observed on superheater’s tubes. Corrosion rates depend mainly on installation design, operating conditions i.e. gas and steam temperature and velocity of the flue gas containing...

The measurement of total mercury in flue gas based on an economical aluminum matrix sorbent was developed in this paper. A sorbent trap consisted of three tubes was employed to capture Hg from flue gas. Hg trapped on sorbent was transferred into solution by acid leaching and then detected by CVAAS. Hg adsorbed on sorbent was recovered completely by leaching process. The 87.7% recovery of Hg in ...

Adsorption of flue gases by single-wall carbon nanotubes (SWCNT) has been studied by means of Monte Carlo simulations. The flue gas is modeled as a ternary mixture of N2, CO2, and O2, emulating realistic compositions of the emissions from power plants. The adsorbed flue gas is in equilibrium with a bulk gas characterized by temperature T, pressure p, and mixture composition. We have considered ...

Volumetric combustion has been developed to realize a high substitution ratio of biomass in co-firing boilers, which features an intensive flue gas internal recirculation inside furnace. However, the characteristics of NOx and SOx emissions in large-scale boilers with volumetric combustion were not fully clear. In this paper, an Aspen Plus model of volumetric combustion system was built up base...

the paper introducedeffects of modified pyrolysis tar on flue gas desulfurization. this experiment selected the pyrolysis tar as the raw material, researched the effects on desulfurization performance under different modification solution, concentration, solid liquid ratio of pyrolysis tar and modified solution, calcination temperature and calcination time by 16 group orthogonal experiments. th...