smelting of hammerable iron and its treatment in antiquity and Medieval produced also by-product: slag. Because of small yields of iron the process produced only small amounts of slag that did not attract attention of smelters concerning its possible use. the use of slag pieces was only accidental. a lot of slag pieces and blocks from slag pit shaft furnaces were used as a material for mound bu...

Current blast furnace technology is a two-stage ironmaking process that requires that iron ore concentrate first be formed into pellets, fired at 1260°C, cooled, transported to the blast furnace, and then re-heated to approximately 1500°C to produce pig iron. This heating, cooling, and then reheating wastes a great deal of energy, which would be saved if the ironmaking process had only a single...

To evaluate the effects of industrial by-products materials on the performance of porous concrete for plant growth, this study investigated the physical, strength, and freeze/thaw resistances of porous concrete for plant growth, prepared by replacing cement with blast furnace slag powder at 60% by weight, and replacing natural stone aggregates with coarse blast furnace slag aggregates at rates ...

In order to examine the effect of ageing on P removal capacity, the phosphorus (P) removal capacity of three types of slag, argon oxygen decarburisation slag (AOD), blast furnace slag (BFS) and electric arc furnace slag (EAF), was examined after 0, 10, 13 and 19 months in batch experiments. The results showed that ageing reduced P removal capacity, e.g. by 78.4% for 19-month-old AOD slag. For B...

This paper will define the slag compositions required to obtain and control optimum foamy slag conditions in the Electric Furnace. In defining the optimal slags, consideration is given to the effects of scrap quality, carbon injection, slag basicity and MgO content. A computer model based on published phase-diagrams has been developed which graphically maps the chemistries for optimal foaming c...

The present paper investigated the process of the slag wool fabrication using high temperature blast furnace (BF) slag modified by coal ash (CA). The liquidus temperature and viscosity of the slag system with different mass ratios of BF slag and CA were measured through an inner cylinder rotation method. The approximate mass ratio used to fabricate the slag wool was therefore determined and sla...

The phosphorus (P) removal of five combinations of dual filters consisting of blast furnace slag (BFS), argon oxygen decarburisation slag (AOD) and electric arc furnace slag (EAF) was evaluated in column experiments with domestic waste water. The columns were fed with waste water for 24 days. The column with only EAF had the best P removal performance (above 93% throughout the experiment). The ...

Prevention and mitigation of acid rock drainage from mining are decisive for limiting environmental impact. Five by-products and industrial remnants (lime kiln dust, blast furnace slag, granulated blast furnace slag, cement kiln dust and fly ash) were investigated for their suitability to prevent acidity and metal(loid)s during leaching from highly sulfidic (50wt%, sulfide) waste rock in small ...

The high performance concrete is a highly complex material that consists of cement, water, blast furnace slag, super-plasticizer, coarse and fine aggregate. All of the materials play a certain role in the compressive strength of concrete. Combined with the information about age, the compressive strength of concrete is determined by eight attributes: 1. Cement (kg/m!) 2. Fly ash (kg/m!) 3. Blast...

This paper describes a review of the potential use of High Strength Incorporating Ground Granulated Blast Furnace Slag and Steel Fiber Reinforced Concrete used in construction industry to improve the structural strength and reduce steel reinforcements requirements. Blast furnace slag (GGBS) has been used as a supplementary material along with the cement. It helps in increasing the durability an...