Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

In this paper a numerical method is used to study the unsteady state natural convection heat transfer within a confined porous media with uniform internal heat generation. The governing equations based on the Darcy model and Bossiness approximations are solved, using the finite difference Alternating Direction Implicit (ADI) method. The developed program was used to simulate natural convection ...

A commercially available computational fluid dynamics code has been used to simulate temperature and flow profiles in the upper, convective heat transfer region of a recovery boiler for different bullnose designs. The convective heat transfer region of the furnace was simulated by examining a zone that begins below the bullnose and ends at the economizer. Superheater tubes and a boiler bank wer...

spray drying is one of the most important processes applied in the industry. the equipment used in this process evaporates water in a very short time and so, need a lot of energy. in this work, we used microsoft excel as an analysis tool for the optimization of fuel usage in this dryer. we have described the process in terms of thermodynamic calculations and mass and heat balance equations. our...

This thesis addresses several aspects of the problem of determining the effect of the low-frequency eddy variability on the mean circulation of the Western North Atlantic. A framework for this study is first established by scale analysis of the eddy and mean terms in the mean momentum, vorticity, and heat balances in three regions of the Western North Atlantic -the northern recirculation, the s...

a mixed solar dryer with a specific mechanism to vary the tilted angle of collector, is utilized to fulfill all tests. the efficiency of the dryers is low because of various reasons such as heat loss of air in an open flow circuit. getting air back toward the air inlet of dryer can increase the efficiency of dryer and decrease drying process period. a new mechanism considered for dryer which co...

Numerical investigation of heat transfer over a backward facing step (BFS), using nanofluids is presented. Different volume fractions of nanoparticles are presented in the base fluid besides different type of nanoparticles have been used. The finite volume technique is used to solve the momentum and energy equations. The distribution of Nusselt number at the top and the bottom walls of the BFS ...

This article discusses the existing calculation of heat for a coal-fired hot-blast furnace. By utilizing the standard method of heat calculation for boilers, considering the relation between the theoretical combustion temperature and the excess air coefficient of the boiler, combining some operational parameters of a coal-fired powder hot-blast furnace, the heat calculation of iron ore concentr...

Heat transfer and laminar air flow over a double backward-facing step numerically studied in this paper. The simulations was performed by using ANSYS ICEM for meshing process and using ANSYS fluent 14 (CFD) for solving. The k-ɛ standard model adopted with Reynolds number varied between 98.5 to 512 and three step height at constant heat flux (q=2000 W/m2). The top of wall and bottom of upstream ...