The application of Inconel 713C is very vast in different industries such as in automobiles, aircrafts, boilers and turbines. In this paper, Inconel 713C specimens were solutionized at 1000 and 1200 °C for 1 hours in order to study changes in phases and the structure of alloy to modify the γ' phase. The optical and the scanning electron microscopy were used to investigate the structure and the ...

A series of TiAlON coatings were synthesized in a gaseous mixture of argon, nitrogen and oxygen by cathodic arc evaporation method using a Ti–Al mosaic target. Oxidation of coatings was carried out by heating the coated samples at the temperatures of 500, 600, 700, and 800°C for 1 h in air atmosphere. It was found that heat treatment changed the microstructure and composition of the coating. Th...

Twinning induced plasticity (TWIP) steels with high manganese percentage (17-35%), are mostly used in automotive bodies. Their microstructure at room temperature is austenitic, and due to the low stacking fault energy, major deformation mechanism in them is twinning inside austenite grains which leads to enhanced mechanical strength in the steel. Due to the important effect of heat treatment pr...

in order to fabrication of transparent glass-ceramics with li-mica nano crystals, the glasses with chemical composition of 94.9 mass% li(1+x)mg3alsi3(1+x)f2 (x=0.5) with 5.1 mass% mgf2 were crystallized. the glasses were fabricated via the conventional melt-quenching technique. mica crystals were precipitated in the glass phase by later heat treatment. glass samples had glass transition tempera...

The object of the present paper is to study temperature distribution and thermal stresses of a functionally graded thick hollow cylinder with temperature dependent material properties. All the material properties except Poisson’s ratio are assumed to be dependent on temperature. The nonlinear heat conduction with temperature dependent thermal conductivity and specific heat capacity is reduced t...

       This article describes the preparation and analysis of nano hydroxyapatite (HA) films on stainless steel 316L through sol-gel technique. The process started with preparation of a nitrate and phosphate sol. After aging the sol for 24 h at room temperature a SS316 substrate was dip-coated and heat-treated at 350 to 450 °C for different times in air. The coating phase and structure on subs...

The effect of pre-heat treatments, followed by a hot forging process, on the microstructure and strength of Co–Cr–Mo alloys was investigated. Four pre-heat treatments were conducted at 1170, 1200, 1230 and 1260 C for three different time condition: 2, 6 and 15 h and then water cooled to room temperature. Tensile tests and XRD analyses were carried out on both as-cast alloy and heat-treated allo...