Strength and toughness are a couple of paradox as similar as strength-ductility trade-off in homogenous materials, body-centered-cubic steels in particular. Here we report a simple way to get ultrahigh toughness without sacrificing strength. By simple alloying design and hot rolling the 5Mn3Al steels in ferrite/austenite dual phase temperature region, we obtain a series of ferrite/martensite la...

Boron steels are used in hot stamping process due to their good mechanical properties. During the stamping process, the dies are exposed to aggressive conditions including adhesive wear, abrasion, thermal stresses and fatigue. In the present work, QRO 90 and UNIMAX slid against 22MnB5 steel in four conditions: with and without hardening treatment and, with and without Al–10%Si coating, in order...

The information about the quantitative effects of alloy elements on the hot strength of steels is scarce and contradictory. Its effects can change according to alloy content and specific conditions of the hot forming process, as they can activate different hardening or softening mechanisms. Three empirical approaches were initially adopted in this work to rank and model hot strength in steels i...

in this study, the four cr-mn-(ni-free) austenitic steels were fabricated by vacuum induction furnace. then plates with 10 mm thickness were fabricated by hot-rolling. corrosion behaviour of the four cr-mn steels in 0.1 m h2so4 solution was investigated using by open-circuit potential, potentiodynamic polarization, and electrochemical impedance spectroscopy (eis). the results indicated that the...

The initial austenite grain size of boron microalloyed steel with three different amounts of boron (20, 40, and 60 ppm) was investigated under different heating temperatures (1150, 1100, and 1050 °C), and hot compression tests of samples in a wide range of temperature (900–1100 °C) and strain rate (0.1–10 s−1) were conducted. It was found that the initial austenite grain size increases with inc...

In this research the effect of initial microstructure on hot deformation behavior in terms of Ferrite-to-Austenite ratios is studied. Two types of stainless steels C1 and C2 were homogenizing heat-treated and deformed under hot compression examinations at temperatures 900ºC and 1100ºC at strain rate of 0.1s-1. The results showed that the flow stress levels of specimens are strongly r...

effect of small al additions, from 0.14% to 0.31% ai, on the hot deformation behavior of low carbon steels containing 1%cu-1.2%mn was investigated in the temperature range of 750-800•c over the strain rate range of 1o.3.1o.1s•1 by a hot compression testing machine. the flow curves obtained, exhibited typical characteristics of dynamic recovery type of softening mechanism, and the critical strai...