The current polymer-exchange membrane fuel cell technology cannot directly use biomass as fuel. Here we present a solar-induced hybrid fuel cell that is directly powered with natural polymeric biomasses, such as starch, cellulose, lignin, and even switchgrass and wood powders. The fuel cell uses polyoxometalates as the photocatalyst and charge carrier to generate electricity at low temperature....

As an inorganic photoabsorber, selenium was used in a mesoscopic solar cell with a hybrid organic-inorganic structure of TiO2/Se/P3HT/PEDOT:PSS/Ag, in which the Se layer was prepared by vacuum thermal deposition and post thermal treatment. The microstructure, photoelectrical properties, as well as the rationality in structural design of the solar cell were illustrated in detail. Finally, the hy...

Constructing a highly efficient bulk-heterojunction is of critical importance to the hybrid organic/inorganic solar cells. Here in this work, we introduce a novel hybrid architecture containing P3HT nanowire and CdSe nanotetrapod as bicontinuous charge channels for holes and electrons, respectively. Compared to the traditionally applied P3HT molecules, the well crystallized P3HT nanowires quali...

A nanocrystal thin-film solar cell operating on an exciton splitting pattern requires a highly efficient separation of electron-hole pairs and transportation of separated charges. A hybrid bulk-heterojunction (HBH) nanostructure providing a large contact area and interpenetrated charge channels is favorable to an inorganic nanocrystal solar cell with high performance. For this freshly appeared ...

Silicon (Si)-based solar cell is by far the most established solar cell technology. The surface of a Si solar cell is usually covered by a layer of transparent material to protect the device from corrosion, contamination and mechanical damage. Here, we replaced this protection layer by a thin layer film of polydimethysiloxane nanowires. Based on this layer and using the conductive layer on the ...

Hybrid photovoltaic thermal (PV/T) solar system comprises a solar collector which is disposed on photovoltaic solar cells. The disadvantage of a conventional photovoltaic cell is that its performance decreases as the temperature increases. Indeed, part of the solar radiation is converted into electricity and is dissipated as heat, increasing the temperature of the photovoltaic cell with respect...

in this paper, the electrical consumption of a research center building is derived of the bills, then with defining of fuzzy bus thermal coefficient objective function for heating, the amount of available heat selling to research center building consumer that is produced by biomass solar hybrid source is calculated. with the capacity determination of biomass solar hybrid source to provide therm...

Metal-substituted phthalocyanine thin films such as copper-phthalocyanine (CuPc) are often used as photo-active and hole transporting layers (HTLs) in fully organic photovoltaic devices. In this work, CuPc is vacuum sublimated on an electron acceptor layer of mesoporous titania (TiO(2)) for the formation of hybrid TiO(2):CuPc solar cell devices. The performance of these hybrid solar cell device...

We fabricated a hybrid energy cell that consists of a triboelectric nanogenerator, a thermoelectric cell, and a solar cell, which can be used to simultaneously or individually harvest the mechanical, thermal, and solar energies. Instead of using an external power source, the hybrid energy cell can be directly used for self-powered water splitting to generate hydrogen. The volume of the produced...

In this paper, the novel application of organic/inorganic perovskite hybrid materials isproposed for grid-connected Photo-voltaic (PV) cells. The perovskite hybrid cells attracted a lot of interest due to their potential in combining advantages of both components. Looking to the future, there is no doubt that these new generations of hybrid materials, born from the very fruitful activitie...