aqueous polymer quenchants are being used increasingly in steel heat treatment industries as a substitution for conventional quenchants. by adjusting the quench parameters of the polymeric media, it is possible to achieve desirable microstructure and mechanical properties in addition to reduction in distortion and cracking. in this work, polyalkylene glycol (pag) aqueous solution was used as th...

a low carbon al-killed ti-added steel was produced in mobarakeh steel complex in iran. mechanical properties and microstructural characterizations of steel in the as-cast, hot-rolled, cold-rolled and annealed conditions are presented. dilatometery tests were carried out to measure the finishing and annealing temperatures of steel. it was found that the addition of small amounts of ti increased ...

the mechanical properties and microstructural developments of 321 stainless steel during thermomechanicalprocess were investigated. the repetitive cold rolling and subsequent annealing wereconducted to achieve nanocrystalline structure in an aisi 321 stainless steel. heavily cold rolling at−20°c was conducted to form martensite in metastable austenitic steel. the process was followed byannealin...

the aim of the paper presented here is to develop the ti - micralloyed steel in otrer to oprtmize the mechanical properties after direct quenching from hot forging temperature. for this purpose, seven melts containing various amounts of titanium were prepared and cast in metal and sand molds. from the ingots, cast in metal mould, tractor links were produced by hot forging. the produced links we...

to investigate the effect of tempering treatment on mechanical properties and the microstructure ofdin 1.4021 martensitic stainless steel, austenite treatment was conducted for the samples at 1000ºc temperature for 60 min and then the samples were oil quenched. later, tempering treatments wereperformed for the samples at 500 ºc and 700 ºc temperatures for 2 and 5 h, respectively; then quenching...

bainitic transformation at low transformation temperatures leads to a microstructure involving fine plates of bainitic ferrite and thin films of retained austenite. this microstructure has shown ultimate tensile strength of about 2.2 gpa, noticeable uniform elongation in the range of 5 to 30%, hardness values of about 600 to 670 hv and impact toughness in the range of 30 to 40 mpa m1/2. with ca...

recently, bulk nano-structured materials produced by severe plastic deformation (spd) have attracted scientists attention.  materials produced by spd are of great importance because of (1) non-porous structure, (2) great mechanical properties such as high strength and toughness and (3) proper dimension for mechanical and physical testing.  several methods have been introduced for imposing the s...

Bainitic transformation at low transformation temperatures leads to a microstructure involving fine plates of bainitic ferrite and thin films of retained austenite. This microstructure has shown ultimate tensile strength of about 2.2 GPa, noticeable uniform elongation in the range of 5 to 30%, hardness values of about 600 to 670 HV and impact toughness in the range of 30 to 40 MPa m1/2. With ca...

Abstract: mechanical properties of AISIH 13 hot-work tool steel have been studied. Cast samples made of the modified new steel were homogenized and austenitized at different conditions, followed by tempering at the specified temperature ranges. Hardness, red hardness, three point bending test and Charpy impact test were carried out to evaluate the mechanical properties together with characteriz...

in this study, physical vapor deposition (pvd) ti-cr-n coatings were deposited at two different temperatures100 and 400ºc on hardened and tempered tool steel substrates. the influence of the applied deposition temperature on the physical and mechanical properties of coatings such as roughness, thickness, phase composition, hardness and young’s modulus were evaluated. phase compositions were stu...