OBJECTIVES To evaluate the effect of silane application and silane heat treatment on lithium-disilicate ceramic when bonded to composite resin. METHODS Twelve blocks of lithium-disilicate (LD) ceramic were fabricated and bonding surfaces were etched using 9.5% hydrofluoric acid (90 seconds). Three experimental groups resulted from the various surface treatment combinations, which included, no...

introduction: the aim of this study was to compare the micro-shear bond strength of composite resin on superficial and deep dentin after conditioning with phosphoric acid and erbium-doped yttrium aluminum garnet (er:yag) laser. methods: thirty human molars were selected, roots were removed and crowns were bisected to provide a total of 60 half-crowns. specimens were ground to expose superficial...

BACKGROUND Molar bonding procedures need continuous improvement to be widely accepted clinically and eventually replace molar bands. MATERIAL AND METHODS The purpose of this study was to determine the effects of enamel micro-abrasion and silane coating of the base of molar tubes on shear and tensile bond strengths of orthodontic molar tubes. A total of 200 third molars were randomly allocated...

BACKGROUND Fiber posts are widely used for restoration of mutilated teeth that lack adequate coronal tooth structure to retain a core for definitive restoration, bond between the fiber post and composite material depends upon the chemical reaction between the post surface and the resin material used for building up the core. In attempt to maximize the resin bonding with fiber post, different po...

objective: the aim of this study was to evaluate the microtensile bond strength to sound and caries-affected dentin using single bond and adper prompt-l-pop adhesives. materials and methods: sixteen extracted human molars with carious lesions extended halfway through dentin were ground to expose the caries affected and the surrounding normal dentin. the samples were divided into two groups of e...

OBJECTIVE The purpose of this study was to measure the micro-tensile bond strength (microTBS) of two adhesives to dentin and to correlate this microTBS with the micro-tensile fracture strength (microTFS) of primer-adhesive mixtures of the two adhesives. METHODS The three-step etch&rinse adhesive OptiBond FL (Kerr) and the two-step self-etch adhesive Clearfil SE Bond (Kuraray) were used to bon...

objective: the objective of this study was to compare the tensile bond strength of metal brackets bonding to glazed ceramic surfaces using three various surface treatments. materials and methods: forty two glazed ceramic disks were assigned to three groups. in the first and second groups the specimens were etched with 9.5% hydrofluoric acid (hfa). subsequently in first group, ceramic primer and...

The effects of dentin wetness on the bond strength and adhesive interface morphology of universal adhesives have been investigated using micro-tensile bond strength (μTBS) testing and confocal laser scanning microscopy (CLSM). Seventy-two human third molars were wet ground to expose flat dentin surfaces. They were divided into three groups according to the air-drying time of the dentin surfaces...

OBJECTIVES Bond strength between adhesive systems and the tooth structure is influenced by a large number of variables, which makes the comparison among studies virtually impossible. Also, failure often times propagates into the dental substrate or the composite, deeming the results questionable at best. In spite of the increased popularity gained by micro-tensile and micro-shear tests, in vitr...

Background and Aim: Recurrent caries and low bond strength are the main causes of composite restorations failure. This study sought to assess the effect of chlorhexidine (CHX) on micro-shear bond strength (MSBS) to dentin of a fourth generation adhesive system and a universal bonding agent after aging. Materials and Methods: This in vitro study used 32 extracted third molars and 3-5mm thick de...