This paper discusses the fabrication of microfluidic channels using micro end milling and micro electrical discharge (ED) milling on metals and polymers. The width of the microchannels fabricated by micro end milling was 100-800 μm with 1-2 aspect ratio. The average surface roughness values were 100-200 nm and 80-120 nm on metals and polymers respectively. The end milling was found to form more...

For time and cost saving reasons, the lowest surface roughness possible is sought in milling operations. High speed milling is recommended in order to minimise the amount of material to be removed in subsequent finishing operations, e.g. grinding, electrical discharge machining or manual polishing. Several roughness parameters are usually employed for the characterization of polished surfaces. ...

The deformation of aeronautical monolithic components due to CNC machining is a bottle-neck issue in the aviation industry. The residual stress releases and redistributes in the process of material removal, and the distortion of the monolithic component is generated. The traditional one-side machining method will produce oversize deformation. Based on the three-stage CNC machining method, the q...

Abstract: Plain Milling is one of the progressive enhancements of miniaturized technologies which have wide range of application in industries and other related areas. Plain milling cutters are widely used in roughing and finishing of parts. The milling cutter geometry and distribution of inserts on the cutter body vary significantly in industry depending on the application. This paper presents...

Two-dimensional (2D) materials can be produced using ball milling with the help of liquid surfactants or solid exfoliation agents, as ball milling of bulk precursor materials usually produces nanosized particles because of high-energy impacts. Post-milling treatment is thus needed to purify the nanosheets. We show here that nanosheets of graphene, BN, and MoS2 can be produced by ball milling of...

In pharmaceutical industries, most active pharmaceutical ingredients are poorly water soluble, and therefore milling processes are important to obtain fine particles that can be easily dissolved in the body. However, the main purpose of milling is micronization of particles. From the viewpoint of fine particle preparation in the formulation process, milling has not been investigated sufficientl...

Experimental & numeral study of temperature distribution during milling process, is important in milling quality and tools life aspects. In the present study the milling cross-section temperature is determined by using Artificial Neural Networks (ANN) according to the temperature of certain points of the work piece and the point specifications and the milling rotational speed of the blade. In t...

Cross-sectional transmission electron microscopy (TEM) sample preparation of ZnSe/GaAs epitaxial films is investigated. Conventional argon ion milling is shown to produce a high density (approximately 5-8 x 10(11)/cm2) of small (diameter approximately 60-80 A) extended defects (stacking faults, microtwins, double positioning twins, etc.). In addition, transmission electron diffraction results i...

Rice milling plays a key factor in determining rice quality and value. Therefore accurate quality assessments are critical to the rice industry. This study was undertaken to assess the effect of exposing rice to elevated temperatures during milling, on cooked rice texture and rice flour pasting properties. Two long (Cybonnett and Francis) and one medium (Jupiter) rice (oryzae sativa L.) cultiva...

The International Rice Research Institute (IRRI) Test Tube Mill and the Kett ”Pearlest” Polisher were evaluated in terms of milling performance in comparison with a McGill No. 2 Mill. Degree of milling (DOM), evaluated in terms of percent bran removal (the percentage of weight lost during milling) from brown rice, and whole kernel yield (WKY) were compared using sample lots of medium– and long–...