CuNiSi alloys are widely used for lead frames and connectors due to the combination of high strength electrical conductivity. In this work, microstructures, properties precipitation behaviors cryo-rolled with different Cr additions were investigated. The results show that microstructures mainly composed nano-sized deformation twins. During aging, discontinuous gradually takes place continuous o...

In this work, the microstructural evolutions and mechanical properties of an as-cast Mg-10Gd-4Y-1.5Zn-0.5Zr (wt %) alloy during successive multi-pass equal channel angular pressing (ECAP) were systematically investigated by X-ray diffractometer, scanning electron microscopy, transmission electron microscopy, and compression test. The obtained results show that the microstructure of as-cast allo...

A physically-based two-site mean field model has been developed to describe the microstructural evolution due to recrystallization during and after deformation. The model has been applied to predict the recrystallized fraction, recrystallized grain size, and flow stress of 304L austenitic stainless steel during discontinuous dynamic recrystallization (DDRX), post-dynamic recrystallization (PDRX...

in this work dynamic recrystallization behavior of aisi 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 c -1200 c and strain rate range of 0.001 s-1 - 1 s-1. the obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. the flow stress and strain corresponding to the critical, pe...

Two oxide precipitation hardened (OPH) Fe-Al-O-based steels were prepared by mechanical alloying. In addition to the variant using yttria nano-precipitates improve properties, a only alumina precipitates for strengthening was also prepared. Therefore, more economically acceptable of these developed. Hot consolidation is significant production step achieving required properties. performed either...

determination of critical points on hot stress-strain curve of metals is crucial in thermo-mechanical processes design. in this investigation a mathematical modeling is given to illustrate the behavior of metal during hot deformation processes such as hot rolling. the critical strain for the onset of dynamic recrystallization has been obtained as a function of strain at the maximum stress. in a...

A mesoscale model is developed by integrating the rate theory and phase-field models and is used to study the fission-induced recrystallization in U-7Mo alloy. The rate theory model is used to predict the dislocation density and the critical size and density of the recrystallized nuclei due to irradiation. The predicted fission rate and temperature dependences of the dislocation density are in ...

Recent work has indicated that iron (oxyhydr-)oxides are capable of structurally incorporating and releasing metals and nutrients as a result of Fe2+-induced iron oxide recrystallization. In the present paper, we briefly review the current literature examining the mechanisms by which iron oxides recrystallize and summarize how recrystallization affects metal incorporation and release. We also p...

Monte Carlo (MC) simulations for recrystallization were performed using OIM (Orientation Image Microscopy) data sets to define the initial microstructures. Two types of OIM data sets were used as input to the simulations. One type was measured on a warm-rolled interstitial-free (IF) steel sheet. The results were strongly affected by the assumptions used to estimate the stored energy, which is t...