The interaction of vanadium oxide and niobium oxide with A1203 and TiO2 supports is examined with Raman spectroscopy. The Raman spectra of the supported metal oxides reveal that the strong interaction of the metal oxides with AI203 and TiO2 supports results in the formation of two-dimensional surface metal oxide overlayers. The surface vanadium oxide overlayers are unstable to high calcination ...

Transition metal (TM)-doped TiO2 films (TM = Co, Ni, and Fe) were deposited on Si(100) substrates by a sol-gel method. With the same dopant content, Co dopants catalyze the anatase-to-rutile transformation (ART) more obviously than Ni and Fe doping. This is attributed to the different strain energy induced by the different dopants. The optical properties of TM-doped TiO2 films were studied with...

Yellow-colored nitrogen doped TiO2 photocatalyst and a pure TiO2 powder were synthesized via sol-gel method using TiCl4 and urea as raw materials. However, the synthesis procedure for nitrogen doped TiO2 was catalyzed by acid that dialed with controlled precipitation and slow nucleation. According to XRD analysis, the nitrogen doped TiO2 consisted of anatase phase of titania which was a signifi...

The conditions for photocatalytic degradation of ethylenediaminetetraacetic acid (EDTA) in aqueous solution with Fe-doped titanium dioxide (TiO2) were optimized. The degradation efficiencies with Fe-doped TiO2 were better, compared with those obtained with bare TiO2 and Pt-doped TiO2. The effect of various experimental factors, such as photocatalytic dosage, temperature, solution pH and light i...

Titanium dioxide (TiO2) was doped with the combination of several metal ions including platinum (Pt), chromium (Cr), vanadium (V), and nickel (Ni). The doped TiO2 materials were synthesized by standard sol-gel methods with the doping levels of 0.1 to 0.5 atom-%. The resulting materials were characterized by the X-ray diffraction (XRD), BET surface-area measurement, Scanning Electron Microscopy ...

In this study Fe (III)-doped TiO2 nanoparticles were synthesized by sol-gel method at two atomic ratio of Fe/Ti, 0.006 and 0.034 percent. Then the photoactivity of them was investigated on degradation of phenol under UV (<380 nm) irradiation and visible light (>380 nm). Results showed that at appropriate atomic ratio of Fe to Ti (% 0.034) photoactivity of Fe(III)-doped TiO2 nanoparticles increa...

Nanocomposites films of (polymer blend-ceramics) were prepared from (PVA-PAA) blend and (PVA-PAA) blend doped with niobium carbide nanoparticles for humidity sensors have low cost, easy fabrication, high sensitivity, lightweight and high corrosion resistance. The structural, electrical and optical properties of (PVA-PAA-NbC) nanocomposites have been studied. The D.C electrical properties of (PV...

In this paper, N-doped TiO2 (N-TiO2) nanorod arrays were synthesized with hydrothermal method, and perovskite solar cells were fabricated using them as electron transfer layer. The solar cell performance was optimized by changing the N doping contents. The power conversion efficiency of solar cells based on N-TiO2 with the N doping content of 1% (N/Ti, atomic ratio) has been achieved 11.1%, whi...

In this work, nanostructured TiO2 and Cr-doped TiO2 thin films were deposited on glass substrate through sonochemical-chemical vapor deposition (CVD) method. The resulting thin films were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), UV-visible absorption spectroscopy, and photoluminescence spectroscopy techniques. The TiO2 thin film has nanocubic morphology and ...