In this study, a chemical additive made by a combination of polymer, alkaline, and silica nanoparticles is used to control the oil recovery and relative permeability curves. Various parametersincluding the type and concentration of polymer, alkaline, and nanosilica particles have been studied.To evaluate the efficiency of these additives, we performed unsteady state displaceme...

In previous work, flow visualization was used to understand how polymer processing additives (PPA) eliminate sharkskin in linear low-density polyethylene (LLDPE). The PPA migrates to and coats the die wall, induces slippage, and eliminates sharkskin. In this work, the interface between the PPA and LLDPE was further characterized using reflection light microscopy, scanning electron microscopy, e...

Conductive biodegradable materials are of great interest for various biomedical applications, such as tissue repair and bioelectronics. They generally consist of multiple components, including biodegradable polymer/non-degradable conductive polymer/dopant, biodegradable conductive polymer/dopant or biodegradable polymer/non-degradable inorganic additives. The dopants or additives induce materia...

Elasto-inertial turbulence (EIT) is a new state of turbulence found in inertial flows with polymer additives. The dynamics of turbulence generated and controlled by such additives is investigated from the perspective of the coupling between polymer dynamics and flow structures. Direct numerical simulations of channel flow with Reynolds numbers ranging from 1000 to 6000 (based on the bulk and th...

The objective of this study was to investigate the influence of the molecular size of carboxymethylcellulose (cmc) and some hydrophobic polymer additives on the release properties of theophylline from tablet matrices. The cmc matrices were prepared by the conventional wet granulation method. The granules were evaluated for angles of repose, bulk density, compressibility index, and porosity, whi...

A laser-Doppler velocimeter suitable for the measurement of mean and fluctuating flow velocities in water is described. Results of a study using this system in an axisymmetric turbulent jet of water and dilute polymer solutions are given. The laser-Doppler technique is better suited for such measurements than either Pitot tubes or heat-transfer gauges because the Doppler velocity measurements a...

In this study, we prepared high-stability hematite mesocrystals by a facile route without polymer additives. In particular, the rhombic hematite mesocrystals exhibit excellent lithium insertion behavior compared to the hematite single-crystals.

We extend the analysis of the friction factor for turbulent pipe flow reported by G. Gioia and P. Chakraborty [Phys. Rev. Lett. 96, 044502 (2006)] to the case where drag is reduced by polymer additives.

Resin transfer moulding (RTM) is commonly used for the production of high-performance fibre-reinforced polymer composites. In numerous application areas, the addition of fillers is necessary to enhance some properties of the polymer matrix or provide it with additional properties, such as flame retardancy. As many of the applied additives are solid phase, the reinforcement layers may filter the...