The aim of the present study was to evaluate the dimensional accuracy and surface property of titanium casting obtained using a gypsum-bonded alumina investment. The experimental gypsum-bonded alumina investment with 20 mass% gypsum content mixed with 2 mass% potassium sulfate was used for five cp titanium castings and three Cu-Zn alloy castings. The accuracy, surface roughness (Ra), and reacti...

The present study is concerned with the investigation of mechanical properties of A713 alloy castings produced by investment casting process using expandable polystyrene as the pattern material and the plaster of paris as the mould material. Experiments were conducted as per Taguchi’s L9 orthogonal array. Castings were made under the constraint of different process parameters like mould firing ...

This paper deals with the comparative study on the properties of Aluminium alloy (LM6-12%Si) castings in sand casting and Evaporative pattern casting (EPC) process. Thermocouples are used to measure the temperature of the casting during solidification. Signals from the thermocouples are connected to the DAQ (Data Acquisition Card) 6024E.The software development platform used for this applicatio...

Oxygen and nitrogen introduced in three Ni-Cr alloy castings were significantly varied according to both different alloys and different melting methods. The arc melting in Ar blow caused significant increases in the amounts of oxygen and nitrogen uptake, which were influenced by alloy composition. The severe gas absorption by the arc melting in Ar blow resulted in the marked occurrence of poros...

This paper summarizes attempts to incorporate fl y ash into aluminum castings to decrease the energy content, material content, cost, and weight of selected industrial components, while also improving selected properties. It is shown that fl y ash can be incorporated into an aluminum-alloy matrix using stir casting and pressure infi ltration techniques. The sand and permanent mold castings, whi...

The rate of solidification affects the microstructure, quality and mechanical properties of the castings. The analysis of heat transfer in centrifugal casting is very complex due to rapid solidification, rotating mould, opaque mould and high temperature. As the grain size is directly depending on the rate of solidification of the casting, based on grain size the rate of solidification of the ce...

BACKGROUND The thermal expansion of the investment can be restricted by the metal casting ring because the thermal expansion of the ring is less than that of the investment. The ringless casting procedure is in use in clinical dentistry, though there is little scientific data to support its use in fixed partial dentures. In this study, marginal discrepancy of castings produced with the ringless...

Bending property of Ti-Ni alloy dental castings was evaluated in comparison with that of Co-Cr alloy in a cantilever test. Heat treatment effect on the bending property was also investigated in relation to phase transformation. Ti-50.85Ni (mol%) alloy was used, and the shape of bending test specimens was half-rounded in cross section, 2.0mm in diameter. The bending test was carried out at 310K....

Titanium is an ideal material for use in prosthodontics because of its biocompatibility, corrosion resistance, and mechanical strength combined with its lightweight. Recently the use of titanium and titanium alloys for fixed restorations has increased substantially, mainly due to the improvement of techniques for the casting titanium and its alloys. This article reviewed the studies on titanium...